User manual TOPCOM TWINTALKER 1302

[. . . ] 0 - 06/11 UK The features described in this manual are published with reservation to modifications. NL FR DE ES SE DK NO SF IT PT CZ GR HU PL RU SK This product is in compliance with the essential requirements and other relevant provisions of the R&TTE directive 1999/5/EC. The Declaration of conformity can be found on : http://www. Php TOPCOM TWINTALKER 1302 1 INTRODUCTION Thank you for purchasing the TOPCOM Twintalker 1302. [. . . ] 7 USING A PMR DEVICE To communicate between PMR devices they need to be set all on the same channel and within receiving range (up to max. Since these devices use free frequency bands (channels), all devices in operation share these channels(total 8 channels). Anybody with a PMR set to your channel can overhear the conversation. If you want to communicate (transmitting a voice signal) you need to press the PTT - button (Push to talk). Once this button pressed, the device will go into transmit mode and you can speak into the microphone. All other PMR devices in range , on the same channel and in standby mode (not transmitting) will hear your message. You need to wait until the other party stops transmitting before you can reply to the message. At the end of each transmission the unit will send a beep. To reply, just press the PTT - button and speak into the microphone. If 2 or more users press the PTT - button at the same time the receiver will receive only the stongest signal and the other signal (s) will be supressed. Therefore you should only transmit a signal (press PTT - button) when the channel is free . To remove the clip from the unit, push the belt clip (2) towards the antenna, while pulling the clip tab (1). When re-installing the belt clip, a click indicates the BeltClip is locked into position. Pull the battery door tab down (3) and slide the battery cover away from the antenna. DOWN button - Decrease the speaker volume - Select the previous item in the menu. PUSH TO TALK button PTT - Press To Talk or release to listen - Confirm a setting in the menu 12. UP button - Increase the speaker volume - Select the next item in the menu. Channel number Speaker Volume RX icon - Displayed when receiving a signal TX icon - Displayed when transmitting a signal Lock icon - Displayed when the keypad is locked. Battery charge level indicator Scan icon - Displayed when scan mode is active 11 BATTERY CHARGE LEVEL/LOW BATTERY INDICATION The BATTERY CHARGE LEVEL is indicated by the number of squares present inside the BATTERY icon on the LCD Screen. SC TX RX Battery Full Battery 2/3 charged Battery 1/3 charged Battery empty When the BATTERY CHARGE LEVEL is low, the BATTERY icon will flash to indicate that the batteries need to be replaced or recharged. Dispose of batteries at a designated battery disposal unit and not in the household waste. do not short-circuit & dispose of in fire. [. . . ] € When an active signal (one of 8 channels) is detected, CHANNEL SCAN pauses and you will hear the active signal. € When an active signal (one of 8 channels) is detected, press and continue to search for another active channel or to bypass the current channel to deactivate channel TX RX • Press PTT to communicate through the active signal channel or press scan. tOPCOM TWINTALKER 1302 7 ENGLISH TOPCOM TWINTALKER 1302 13. 8 SC BUTTON LOCK • Press and hold for 2 seconds to activate or deactivate the BUTTON LOCK mode. [. . . ]