User manual TORNADO T6636 INSTALLATION INSTRUCTIONS

[. . . ] 23 Replacing the Super Air Clean filter . 24 Replacing the Active Air Clean or Active HEPA filter. 25 Replacing one type of filter with another . 26 When to change the dust compartment filter (for motor protection) . [. . . ] It is also important to observe the flooring manufacturer's cleaning and care instructions. Vacuum carpets and rugs with the brush retracted: ^ Press the foot switch ö. Clean hard flooring which is not susceptible to scratching with the brush protruding: ^ Press the foot switch ä. The ALLERGOTEC floorhead, the ACCU NOVA floorhead and the Turbobrush Some models may be supplied as standard with one of these accessories (see "Optional accessories"). Please refer to the separate operating instructions supplied with these brushes for instructions on use and maintenance. 11 Using the accessories supplied The following accessories are supplied: a Crevice nozzle b Dusting brush (depending on model) c Upholstery nozzle d Accessory holder for 2 or 3 of the above accessories e Filter grille The filter grille is supplied in the box with models which are fitted with Active Air Clean or Active HEPA filters as standard. a - curtains, lightweight fabrics b - upholstery, cushions c - carpets, rugs and runners ( - for daily energy-saving vacuuming e - lightly soiled rugs and fitted carpets f - heavily soiled hard flooring, and for intensive cleaning of carpets The controls vary from model to model. The different options are carried out in sequence. , When vacuuming especially fine dust, e. g. sawdust, sand, plaster, flour, talcum powder etc. , electrostatic charges build up naturally. Under certain conditions these charges will be released. To avoid the unpleasant effects of these discharges, a metal inlay has been incorporated into the underside of the handle. Please make sure that you keep your hand in constant contact with this metal strip during vacuuming. 16 Use Rotary selector ^ Turn the suction power selector manually to the suction power setting you require. + / - foot controls Press the controls to select the suction power you require. Checking the dustbag change indicator ^ Attach the standard floorhead to the suction tube. Do not use any of the other floorheads or attachments as they will cause the dustbag change indicator to give a false reading. ^ Switch the vacuum cleaner on and select the highest power setting. ^ Lift the floorhead off the floor a little. If the marker completely fills the dustbag change indicator, you should replace the dustbag with a new one. How the dustbag change indicator works The dustbag change indicator is set for normal household dust. Normal household dust would contain a mixture of dust, hair, carpet fluff, threads, grit etc. However, if the vacuum cleaner has been used to suck up fine dust, such as plaster, brick dust, cement or flour, the pores of the dustbag will become blocked very quickly. This affects the air permeability of the bag, and the marker will indicate that the bag is "full" even when it is not. If this happens you must still change the dustbag because suction power will be greatly reduced by blocked pores in the dustbag. If, on the other hand, you have vacuumed up a large amount of hair and carpet fluff which typically contains a lot of air, the indicator may fail to react even though the bag is full. [. . . ] After sales service In the event of a fault that you cannot easily remedy, please contact ­ your Miele dealer, or ­ the nearest Miele Service Department. Please note that telephone calls may be monitored and recorded for training purposes. 31 Optional accessories Certain models are supplied as standard with one or more of the following accessories: Important: please observe the flooring manufacturer's cleaning and care instructions. Turbobrush The Turbobrush is particularly suitable for vacuuming cut-pile carpeting, and is operated by the suction power of the vacuum cleaner. It has a rotating brush and is very effective at picking up thread, hairs and fluff. [. . . ]