User manual TOSHIBA 50HP81

[. . . ] The model number and serial number are on the back of your display. Record these numbers in the spaces below. Refer to these numbers whenever you communicate with your Toshiba dealer about this display. 50HP81 Model number: Serial number: TOSHIBA CORPORATION, 2001 WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: To reduce the risk of electric shock do not remove cover or back. [. . . ] To tighten: To loosen: Push the knob Pull Pull The TUNER connector is reserved for future use From monitor Out port on Computer (see page 16) From SERIAL port on Computer (see page 17) L L AUDIO S-VIDEO VIDEO R VD HD PR/CR/R PB/CB/B Y/G AUDIO AUDIO R AV IN COMPONENT/RGB IN PC IN TUNER IN SERIAL AV IN connectors (see page 13, 14) COMPONENT/RGB IN and Audio IN connectors (see page 15) 12 Connections Speaker connection When connecting the speakers, be sure to use only the optional accessory speakers. Refer to the speaker installation manual for details on speaker installation. Make sure to use the supplied ferrite core speaker cables to connect the speakers. Other types of speaker cable are not suitable. 1 Remove the tubes from the ends of the speaker cables. 2 Speakers (Optional accessories) 3 1 2 AV Input connection Connect the signal source equipment (see pages 14 to 17). (Example) When connecting an S-VIDEO VCR (S-VIDEO VCR) L R Audio OUT L Video OUT S-Video OUT AUDIO S-VIDEO VIDEO R AV IN S-VIDEO 4-pin connector Luminance earth Chrominance earth Video input to S-VIDEO connector S-VIDEO Luminance in Chrominance in AUDIO 2×RCA audio cables Audio input to L/R connectors 13 Connections AV Input connection VIDEO signal connection (VCR) R Audio OUT L Video OUT VIDEO RCA-BNC video cable AUDIO 2×RCA audio cables Video input to BNC connector Audio input to L/R connectors L AUDIO S-VIDEO VIDEO R AV IN (VCR) R Audio OUT L Video OUT VIDEO RCA video cable AUDIO 2×RCA audio cables Video input to BNC connector RCA-BNC adapter plug (supplied) Audio input to L/R connectors 14 Connections COMPONENT/RGB Input connection Component signals (Y, PB, PR) connection DVD Player L AUDIO VD Audio OUT L DVD (Y, PB, PR) OUT Y PB PR HD PR/CR/R PB/CB/B Y/G R R COMPONENT/RGB IN RCA-BNC adapter plug (supplied) Y, PB, PR 3×RCA video cables AUDIO 2×RCA audio cables Audio input to L/R connectors Notes: (1) Change the "COMPONENT/RGB-IN" setting in the "SET UP" menu to "Y/PB/PR". (see page 30, 32) (2) Additional equipment and cables shown are not supplied with this set. RGB signal (R, G, B, HD, VD) connection Example of input signal source HDTV-compatible VCR RGB input to R, G, B, HD, VD connectors 5×BNC RGB cables L or RGB camera VD HD AUDIO 2×RCA audio cables Audio input to L/R connectors AUDIO VD HD PR/CR/R PB/CB/B Y/G R COMPONENT/RGB IN Notes: (1) Change the "COMPONENT/RGB-IN" setting in the "SET UP" menu to "RGB". (see page 30, 32) (2) Additional equipment and cables shown are not supplied with this set. 15 Connections PC Input connection COMPUTER AUDIO PC IN POWER / R - STANDBY G POWER ON INPUT -- VOL + Gender changer (if necessary) RGB PC cable Ferrite core (supplied) Audio Less than 7 7/8" (20 cm) D-sub 15p 1/8" (3mm) stereo plug Connect a cable which matches the audio output port on the computer. Notes: (1) Computer signals which can be input are those with a horizontal scanning frequency of 15. 5 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, signals exceeding 1200 lines may not be displayed properly. ) (2) The signal resolution is a maximum of 1024 × 768 dots when the aspect mode is set to "NORMAL", and 1366 × 768 dots when the aspect mode is set to "FULL". If the signal resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity. (3) The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you will need to make setting changes to the computer at the time of connection. (4) Some PC models cannot be connected to the set. (5) There is no need to use an adapter for computers with an MS-DOS 5 (or greater) compatible D-sub 15P port. (6) The computer shown in the illustration is for example purposes only. (7) Additional equipment and cables shown are not supplied with this set. (8) Do not set the horizontal and vertical scanning frequencies on the PC for PC signals which are above or below the specified frequency range. Signal Names for D-sub 15P Connector 11 12 13 14 15 6 1 7 2 8 3 9 10 4 5 Pin layout for PC input terminal Pin No. 1 2 3 4 5 Signal Name R G B GND (Ground) GND (Ground) Pin No. 6 GND (Ground) 11 7 GND (Ground) 12 8 GND (Ground) 13 9 NC (not connected) 14 10 GND (Ground) 15 Signal Name GND (Ground) SDA HD/SYNC VD/SYNC SCL 16 Connections SERIAL connection The SERIAL port is used when the Wide Plasma Display is controlled by a computer. COMPUTER SERIAL 6 1 2 7 3 8 4 9 5 RS-232C cable Pin layout for RS-232C D-sub 9p Notes: (1) Use the RS-232C cable to connect the computer to the Wide Plasma Display. (2) The computer shown is for example purposes only. (3) Additional equipment and cables shown are not supplied with this set. The SERIAL port conforms to the RS-232C interface specification, so that the Wide Plasma Display can be controlled by a computer which is connected to this port. The computer will require software which allows the sending and receiving of control data which satisfies the conditions given below. [. . . ] Honolulu, Hawaii 96814 (808) 591 -9281 All warranties implied by state law, including the implied warranties of merchantability and fitness for a particular purpose, are expressly limited to the duration of the limited warranties set forth above. With the exception of any warranties implied by state law as hereby limited, the foregoing warranty is exclusive and in lieu of all other warranties, guarantees, agreements and similar obligations of manufacturer or seller with respect to the repair or replacement of any parts. In no event shall TACP or THI be liable for consequential or incidental damages. No person, agent, distributor, dealer or company is authorized to change, modify or extend the terms of these warranties in any manner whatsoever. [. . . ]