User manual TOSHIBA B-880-QQ

[. . . ] TEC Thermal Printer B-880-QQ SERIES Owner's Manual This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operations of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. [. . . ] 7-1 Head Lever Position 1: Labels or thin tag paper 2: Thick tag paper OPEN: Ribbon/media replacement 3. 7-2 shows, unroll and loosen the ribbon a little. Insert the ribbon under the print block so that the ribbon supply end is positioned backside of the printer. Ribbon Ribbon Core Fig. Push the ribbon core against the spring guide wheel, align the protrusion of the guide wheel with the notch of the ribbon core, then set the ribbon. To remove the slack of the ribbon, turn the ribbon core in the direction indicated by the arrow. If the ribbon wrinkles while printing, move the ribbon levers back or forth until the wrinkle is removed. Protrusion Guide Wheel STEP 1 Spring Guide Wheel Notch STEP 2 Ribbon Core Ribbon Ribbon Lever Fig. 7-3 NOTE: When removing the ribbon, be careful not to snag the ribbon on the part 8. Turn the head lever to the proper position depending on the used media. 7-1) 1: Labels or thin tag paper 2: Thick tag paper CAUTION: When using labels ensure that the head lever is set to position 1. 7-2 8. To reduce the risk that fingers, jewelry, clothing, etc. , be drawn into the moving parts, push the switch in the "OFF" position to stop movement. To avoid injury, be careful not to catch or jam your fingers while opening or closing the cover. 1. Install the holder stand on the rear of the printer. Loosen the screw A and slide the media guides outside. Media Guides Holder Stand Release Lock Screw A Fig. 8-1 CAUTION: DO NOT MOVE the Media Guides using the screw A . 3. Lock the Media Holder securely with the Lock Lever. Pass the Holder Shaft through the Media, then set one of the Media Holders and lock it securely with the Lock Lever. Media Holder Media Holder Holder Shaft Holder Shaft Lock Lever Media Lock Lever Fig. Turn the Lock Levers of the Media Holders to the unlock position and readjust the Media position to the center. Then lock the Media Holders securely with the Lock Levers. Tighten the screw A firmly. Media Guide Lock Lever Media Holder Media Media Holder Media Guide Screw A Holder Shaft Holder Stand Notch Bush Fig. 8-3 NOTE: Set in the bushes of the Holder Shaft into notches of the Holder Stand securely. 6. The black mark/feed gap sensor is selectable between the fixed type and the movable type by changing the printer's PARAMETER settings. [. . . ] Replace the flash memory card or ATA card and retry. Turn the power off and contact your Authorized Service representative. Turn the power off, re-seat the flash memory card or ATA card and try again. Replace the flash memory card or ATA card and retry. [. . . ]