User manual TOSHIBA CM1320A

[. . . ] SPECIFICATIONS OF ELECTRICAL PARTS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 SUMMARY · The infrared remote controller within this manual conforms with the protection requirements of European Directives 89/ 336/EEC Electromagnetic Compatibility and 73/23/EEC Low Voltage. -2- 1. Remote Functions (Cover closed) ON/OFF Button · Push this button to start operation. (A receiving beep is heard) · Push the button to stop operation. (A receiving beep is heard) Temperature button (TEMP) The set temperature is increased to a max 30ºC. [. . . ] Cautions · · · · · · The air conditioner will not operate if curtains, doors or other materials block the signal from the remote controller to the indoor unit. Protect the remote controller from moisture. Do not expose the remote controller to direct sunlight or heat. If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner may not function properly. If the room using the air conditioner has fluorescent lighting with electronic starters, signals may not be properly received. If you are planning to use such fluorescent lamps, consult your local dealer. If other electrical appliances react to the remote control, either move these appliances or consult your local dealer. -8- 1-4 OPERATING MODES Once selected the operating mode is stored in the unit's microcomputer memory. Thereafter, the air conditioner will operate under the same conditions when you operate the ON/OFF button of the remote controller. 3 1 2 1-4-1. AUTO Operation When you set the air conditioner in AUTO mode, it initially selects cooling mode. Then depending on the room temperature the mode of operation may change. Operation Steps (1) · (2) · · (3) · · Stop: · Note: · · Supply Power On The OPERATION LED on the remote receiver starts flashing. Select the required temperature between 17°C to 30°C. · The fan speed indicator displays AUTO. · Low indoor fan speed will be selected automatically. (3) ON/OFF button · Push this button again to start the air conditioner. · The OPERATION LED on the remote receiver unit lights. Operation starts after approximately 3 minutes. (If you select FAN ONLY mode, the unit will start immediately. ) Stop: ON/OFF button · Push this button again to stop the air conditioner. Operation Econo can be selected in the AUTO, COOL and HEAT modes of operation. The air conditioner now operates in the economy mode. 1-4-7. (4) · Louver Operation AUTO Button When this button is first pressed the louver will oscilate, its position can be fixed in a desired direction by pressing the button again. -11- 1-5. 1-5-1. · · · TIMER OPERATION Setting the Clock Push the clock set button in the battery compartment. The clock " : " starts flashing. [. . . ] make sure " " is showing on the display. All clear button Switch for selecting Switch for selecting service mode service mode All clear button ACL CLOCK ACL CLOCK Battery cover Rear bottom cover (Rear bottom of remote controller) 2-2-2. Reverting to Normal Mode Push the all clear button (ACL) on the rear bottom of the wireless remote control with a tip of pencil for more than 3 seconds. Make sure the operation mode display, fan speed display, clock display and setting temperature display are turned on and " : " of the clock display is flashing. Cautions when carrying out servicing After completion of servicing, always push the all clear (ACL) button to return the operation mode to the normal mode. After completion of servicing by the check code, isolate the power supply and then reconnect to reset memorized contents of the microcomputer to the initial status. 2-2-3. [. . . ]