User manual TOSHIBA CX36H64

[. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the distance between the equipment and receiver. [. . . ] This unit selects the playback tape speed SP or SLP automatically. When you select the TV/VCR mode during DVD playback, DVD playback will change to the still mode, and after 5 minutes it will change to the resuming stop mode automatically. 34 5Q10501A [E]p33-37 34 4/17/04, 3:31 PM Special playback CM SKIP REV SLOW PLAY FWD PAUSE/STILL D. TRACKING TRK +/ Picture search Reverse picture search function Press REV once or twice during the playback. Forward picture search function Press FWD once or twice during the playback. SPEED SEARCH TIMES TAPE SPEED SP (Standard Play) SLP (Super Long Play) PICTURE SEARCH SPEED PRESS ONCE PRESS TWICE 3X 9X 5X 15 X Digital tracking controls When a tape is played, the Digital Auto Tracking system automatically adjusts the tracking to obtain the best possible picture. If noise bars appear during playback, adjust the tracking manually as follows: Press TRK + / to obtain the best possible picture. "MANUAL TRACK" will appear for 4 seconds on the screen. To resume automatic tracking, press D. TRACKING. "DIGITAL TRACK" will appear for 4 seconds on the screen. Playback (VCR) MANUAL TRACK DIGITAL TRACK Still picture Notes: "SP" is more appropriate as less noise appeared during search Press PAUSE/STILL during playback. and still playback for tape recorded in SP. To resume normal playback, press PLAY or PAUSE/STILL. The audio output is muted during SPEED SEARCH, STILL, If the still picture jitters excessively, press TRK + / to FRAME ADVANCE and SLOW MOTION. Video heads may eventually wear out and should be replaced when they fail to produce clear pictures. To help prevent video head clogging, use only good quality VHS tapes. Discard worn out tapes. Before playback or recording, press COUNTER RESET to set the counter to "00:00:00". TV/VCR 8:40AM THU CH 012 00:00:00 SP 3 4 5 Begin playback or recording. PLAY REC Press STOP. TV/VCR 9:00AM THU CH 012 STOP 00:20:00 SP Press ZERO RETURN. The tape will rewind and automatically stop at the "00:00:00" position. TV/VCR 9:00AM THU CH 012 00:00:00 SP 37 5Q10501A [E]p33-37 37 4/17/04, 11:58 AM Recording (VCR) TV/VCR 09 CHANNEL REC STOP PAUSE/STILL SP/SLP Recording a TV program Recording and viewing the same TV program. / Recording a TV program To stop recording Press STOP to stop recording. " " will appear on screen for about 4 seconds. 1 2 3 4 1 4 7 Load a cassette tape with the erase prevention tab intact. The unit will automatically turn on. Press SP/SLP to select the desired tape speed SP or SLP. The tape counter and SP or SLP will appear on the screen for about 4 seconds. 00 : 00 : 00 SP STOP To stop recording temporarily Press PAUSE/STILL to avoid recording unwanted material. " " will appear on the screen and the REC/OTR indicator will blink on and off. Press PAUSE/STILL or both REC at the same time to continue the recording. Select "TV" or "CABLE" to the appropriate position 26 . TV - VHF/UHF channels CABLE - Cable TV channels Press Direct channel selection (09) or CHANNEL / to select the channel to be recorded. 2 5 8 0 3 CH 110 PAUSE/STILL REC/OTR 6 9 CHANNEL Note: The pause function will be released after 5 minutes to prevent damage to the tape or the unit. The unit will change to the STOP mode. 5 Press both REC at the same time. " " will appear on the screen for about 4 seconds and the REC/OTR indicator on the front panel will light. REC Auto Rewind feature This VCR will automatically rewind the tape when the tape has ended (except during OTR and timer recording). It will also eject the tape. Note: If the erase prevention tab is removed, the tape will eject when both the REC buttons are pressed for recording. REC/OTR +0 Notes: If power is switched off during recording, the TV and the DVD sections go off and the VCR continues to record. Press the STOP button to halt the recording and turn off the VCR. The unit channel cannot be changed during recording. [. . . ] During this period, TACP will repair a defective product or part, without charge to you. You must deliver the entire set to an Authorized TACP Service Station. You pay for all transportation and insurance charges for the set to and from the Service Station. Limited One (1) Year Warranty TACP further warrants the parts in this product against defects in materials or workmanship for a period of one year after the date of original retail purchase. During this period TACP will replace a defective part without charge to you, except that if a defective part is replaced after ninety (90) days from the date of original retail purchase you pay labor charges involved in the replacement. [. . . ]