User manual TOSHIBA DKT2404-DECT

[. . . ] TOSHIBA Telecommunication Systems Division DKT2404-DECT User Guide April 2009 Publication Information Toshiba America Information Systems, Inc. Telecommunication Systems Division Publication Information Toshiba America Information Systems, Inc. , Telecommunication Systems Division, reserves the right, without prior notice, to revise this information publication for any reason, including, but not limited to, utilization of new advances in the state of technical arts or to simply change the design of this document. Further, Toshiba America Information Systems, Inc. , Telecommunication Systems Division, also reserves the right, without prior notice, to make such changes in equipment design or components as engineering or manufacturing methods may warrant. CIX-UG-DKT2404-DECT-VA-E Version A2, April 6, 2009 Our mission to publish accurate, complete and user accessible documentation. [. . . ] The last number dialed is shown in the LCD and the number is sent to the Strata CIX for processing. Redial digit length can be up to 32 digits. If, after talk mode is established, F8 is the first button pressed, it acts as redial; in other cases, F8 operation is ignored (see example below): Channel Change Channel change occurs automatically. CIX No Service In cases when the TALK or speaker-icon button is pushed and connection to the CIX cannot be established, or if the base station doesn't respond, the handset goes to idle mode after blinking the following message for seven seconds: Strata CIX DKT2404-DECT User Guide 04/09 25 Operation & Setup Operation with the Strata CIX Out of Range ä When the handset is in the idle mode, it will show this screen when it cannot find the base station (Out of Range). ä If the TALK, speaker-icon or one of the F1-F12 buttons are pressed but the handset cannot establish an RF link with the base station, the handset will sound an error tone and show the Out of Range message. ä While talking, if the handset cannot receive a signal from the base station for appox. five seconds, it goes to idle mode - conversation is dropped - with an error tone. In this case, the LCD shows the message below. 26 Strata CIX DKT2404-DECT User Guide 04/09 Operation & Setup Operation with the Strata CIX Low Battery Your DKT2404-DECT comes equipped with one rechargeable BT1009 battery that provides 16 hours of talk time and seven days standby time (fully charged). The LCD shows the battery according to the remaining capacity. Low battery symptoms are: · On a call · Battery status icon changes to battery low. · Handset keeps talk mode and the battery low alert tone is emitted every 30 seconds. · In standby mode · Battery status icon changes to battery low. · Charge Battery message blinks on and off on the display. To restore your battery capacity, return the handset to the charging unit or replace the handset battery with a charged one. After the handset is on the charging unit for one minute he battery icon stops blinking and the battery low tone stops. For more information on installing and charging the battery, see Step 7: "Install Handset Battery Pack". Mute ä During talk mode, press the menu/MUTE button on the front of the handset. The MUTE icon displays on the screen and the microphone is dead. ä Press the menu/MUTE button again to cancel the mute condition. Finishing the conversation also cancels the mute condition. Strata CIX DKT2404-DECT User Guide 04/09 27 Operation & Setup Operation with the Strata CIX Hands Free ä Press the speaker-icon button in either standby mode or during a call. The handset goes to hands-free operation and the speaker icon displays on the screen. ä Press TALK to return to return to "non-speaker" (normal) operation. ä Press the speaker-icon button (or TALK button twice) to end the call and return to idle. Volume Setting ä Volume setting can be changed from Levels 1 to 6 (highest). Talk mode, handsfree mode and headset mode each have volume settings. When the +/- buttons are pressed, the handset immediately goes to volume setting mode, sounding the ringer and displaying the current volume for five seconds. During this time use the +/- buttons to change the volume. Ring Volume Setting When the + (up) button is pressed when the handset is idle, the handset goes to the Ringer Volume setting and displays the current setting. The Ring volume is changed as follows: Press the up button to show the next screen 28 Strata CIX DKT2404-DECT User Guide 04/09 Operation & Setup Operation with the Strata CIX Pressing the up button again shows this screen Pressing the up button a third time shows this screen ä When the ringer volume is Off (Vibrate), the handset vibrates instead of ringing. If the handset is on the charger and a call comes in, the ringer outputs the low tone instead of vibrating. ä If the ringer mute is on, the handset will output a ringer tone or it will vibrate in Ringer Volume Setting mode. ä Pressing TALK or the speaker-icon buttons in Ring Volume setting mode cancels the ringer volume setting and the handset goes idle. Ringer Mute ä If the - (down) button is pressed and held for two seconds in standby mode or in incoming call mode, the handset sets the Ringer mute on, turns on the Ringer mute icon and stops the ringer. Press and hold the - button for two seconds to turn the Ringer mute off (unmute). [. . . ] Do not use any liquids or solvents. 48 Strata CIX DKT2404-DECT User Guide 04/09 Troubleshooting and Specifications Charging Spare Battery Packs Charging Spare Battery Packs The charging unit of your cordless telephone is equipped to charge the spare battery pack with or without the handset in the front slot. Slide the spare battery pack into the second slot in the charging unit until the retaining clip snaps over the top of the pack. If the indicator doesn't light, check to see that the AC adapter is plugged in, and that the battery pack is making good contact with the unit's charging contacts. Note Charge the battery pack without interruption for 12~15 hours. [. . . ]