User manual TOSHIBA ET1

[. . . ] OWNER’S MANUAL 3LCD PROJECTOR TLP-ET1B TLP-ET1E TLP-ET1U Others Maintenance Operations Preparations Before Using English Before Using SAFETY PRECAUTIONS The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (ser vicing) instructions in the literature accompanying the appliance. WARNING: Handling the cord on this product or cords associated with accessories sold with this product, will expose you to lead, a chemical known to the State of California to cause birth defects or other USA only reproductive harm. FCC Radio Frequency Interference Statement Note: This equipment has been tested and found to comply with the limits for a Class B digital device, USA only pursuant to part 15 of the FCC Rules. [. . . ] Select whether the placement style is front or rear projection. Front/Rear Lamp power Notes • “Projection size” can also be adjusted by using ( ) and ( ) buttons, on the remote control or main unit. ) (See • Decreasing the projection size may affect image quality slightly. ) • “Picture mode” can also be set via the PICTURE MODE button on the remote control or the “Picture adjustp. (See • “Screen size” can also be set via the SIZE button on the remote control or the “Default setting” menu. ) • “Keystone”, “Up/down shift”, “Lamp power”, and “Projection mode 1” can also be adjusted via the “Default setting” menu. ) • The items set and adjusted on the “Easy setting” menu are saved when the power is turned off with the ON/ STANDBY button. They are not saved if power is disconnected by unplugging the power cord or by a power failure. g Correction of keystone distortion When the tilt stand (see p. 20) is used to change the projection angle, the picture will undergo keystone (trapezoid) distortion. The projector is capable of correcting this keystone distortion. Before correction After correction • Depending on the amount of keystone adjustment and the content of images, some information may be lost or the picture quality may suffer. Keystone adjustment will not change the shape of the menus. 23 Others Maintenance Operations Preparations Projection mode 1 Before Using English Operations Changing the projection size You can change the projection size (picture area size on the screen). Pressing the ( ) button decreases the projection size. ( ) button increases the Pressing the projection size. You cannot make the image larger than its original size. Remote control Control panel Notes • The “Projection size” can also be adjusted via the “Easy setting” menu. ) • Decreasing the projection size may degrade the images more or less. 24 Operations The projection screen of this projector is 16:9, though the screen size can be changed depending on the input signal. Press the SIZE button on the remote control. Pressing the SIZE button for the first time displays the current screen size. [. . . ] ) Was the lamp timer reset after the lamp was replaced?21) Was no signal being input for 10 minutes?Is the input signal supported by the projector?) Are there any problems with the signal source such as the video tape? [. . . ]