User manual TOSHIBA FT6003

[. . . ] Do not use liquid cleaners or aerosol cleaners. Do not use this product near water sources, such as bath tubs, wash bowls, kitchen sinks, laundry tubs, wet basements, or swimming pools. Do not place this product on an unstable cart, stand, or table. The telephone may fall, causing serious damage to the telephone. [. . . ] · The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use. ) 5 2. CHARGE THE BATTERY PACK Note Black Red Use only the supplied battery pack (TRB-1981; power source 800 mAh, 3. 6V). q Remove the battery compartment cover on the back of the handset by sliding it down. w Plug the battery pack cord into the connector in the battery compartment in correct polarity. e Place the battery pack in the battery compartment. r Put the battery compartment cover back by sliding until it snaps into place. Make sure not to get the wires of the battery pack caught in the cover. If the IN USE/CHARGE LED does not light, make sure the AC adaptor is plugged in securely and that the electrical outlet is working and not controlled by a light switch. It is important to charge the battery for IN USE/ CHARGE 12 to 16 hours continuously without LED any interruption before you use the handset for the first time. Charging contacts Note The battery pack is not charged properly if the charging contacts are dirty or tarnished. Clean the contacts occasionally with a dry cloth. 6 After the battery pack is fully charged; Operation While in use (Talk mode) While not in use (Standby mode) Approx. battery life up to 6 hours up to 10 days When TALK/BATT LOW LED blinks, all handset buttons are disabled and the battery needs to be charged. · If you place the handset on the base unit while the headset is connected, be sure the handset is placed properly. 13 USING A BELT CLIP (option) You can attach an optional Belt Clip (part #. RC009263) to the handset in order to carry it on your belt. Attaching the Belt Clip to the Handset Insert the Belt Clip tabs into the holes on each side of the handset until they click. Note Be sure to insert the tab properly into each hole to prevent the belt clip from falling off. Removing the Belt Clip from the Handset Pull both sides of the Belt Clip to release the tabs from the holes. Note Remove the Belt Clip carefully from the handset, taking care not to hurt your fingers or damage your nails. 14 MEMORY DIALING You can store up to 10 telephone numbers in memory. Notes In memory dialing operation, · If more than 20 seconds elapse between pressing buttons, the operation will be canceled and you must start over again. · If you press a wrong button, an error tone sounds and the handset returns to standby mode. · If a call comes in, the operation will be canceled and you will hear the ring. 1. STORING NUMBERS You can store up to 20 digits including #, , TONE, and PAUSE in one memory address. q Pick up the handset from the base unit. (Do not press w Press r Press MEM TALK ). . . e Dial the telephone number you wish to store. (up to 20 digits). MEM t Enter the memory address (0 to 9) at which you wish to store the phone number dialed in step 3. You will hear a long beep when the number is successfully stored. To store more telephone numbers, repeat the steps from w to t. [. . . ] · The handset is not on the base. Place the handset on the base properly · The handset is too far from the base unit. Place the handset on the base unit to recharge. · The base unit is located in a place with high interference. [. . . ]