User manual TOSHIBA FT8001AW

[. . . ] IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. [. . . ] Flip the switch hook tab over so the tab holds the handset. Telephone Line Cord Single-Line Telephone Jack (RJ11C) Power Outlet (AC 120V, 60Hz) AC Adaptor 7 · Route the cords through the guides. · Place the base unit on the posts of the wall plate and push down until it is firmly seated. · USE ONLY WITH Supplied AC ADAPTOR (TAC-8001 power source AC 120V, 60Hz/DC 9V). Notes · Do not use any outlet controlled by a wall switch. · If you don't have a standard wall plate, cut out the template on this page and use it to position two screws (minimum length of 13/8 inches) into the wall with the heads protruding about 1/4 inch. CUT CUT Wall mount template IMPORTANT: · Before mounting, select a wall area of sufficient strength. If mounting on wallboard or in an area of questionable strength, locate a stud for maximum support of your telephone. The TALK/BATT LOW LED will light. 1, 2 w To hang up, press TALK or place the handset on the base unit. The TALK/BATT LOW LED turns off. 11 3. INTERFERENCE OR STATIC If you hear noise during a call, press CH to select another channel. The TALK/BATT LOW LED blinks while changing a channel. 4. CHANGING THE RINGER VOLUME Press VOL/RING to select one of four ringer tone and volume combinations during standby mode. Each time you press VOL/RING , the setting will change. 5. CHANGING THE HANDSET SPEAKER VOLUME During a telephone call, press VOL/RING to select one of three speaker volume levels; Low, Medium and High. The setting will remain in effect even after you hang up the current call. Note The High setting may be too loud because it is set for hearing aid compatibility. 6. REDIALING Press TALK and then press RDL/P (Redial/Pause). The last number called (up to 32 digits) will then be dialed again. 7. USING THE CALL WAITING SERVICE, ETC. To use this feature, you must subscribe to the Call Waiting service. When you hear a call-waiting tone while you are already talking on the phone, simply press FLASH . To take the original call back, press FLASH again. Note Pressing FLASH without receiving a Call Waiting signal may disconnect the current caller. 12 8. SENDING TONE SIGNAL (for Pulse service user) Even if you have Pulse service (the dial mode is set to Pulse), you can use this phone with banking and other phone services requiring touch tone signals. q Dial the service number and wait for the connection. w Press TONE/ , then enter the numbers required. You will hear the tones on the line. 9. [. . . ] · Interference from TV, Microwave oven, Computer and electrical appliances. Press CH to select a clearer channel, or relocate the base unit. · The volume control is set too high. · The base antenna is not in a vertical position. [. . . ]