User manual TOSHIBA FT9003

[. . . ] To use this unit in your country, first change the unit's region setting to match your country (page 32). Change the unit's display language as needed (page 16). (For Czech and Slovakia) This cordless telephone is possible to use according to General licence No. : VO-R/8/08. 2005-23 (for Czech), VPR-7/2001 (for Slovakia). TG8051_8061FX(e-e). book Page 2 Monday, April 25, 2011 11:42 AM Table of Contents Introduction Model composition. 41 Listening to messages using the base unit . [. . . ] *12You can set the handset display backlight while on charge. ­ "On": Backlight is on (dimmed). ­ "Off": Backlight turns off after 10 seconds of charging. *13Turn this feature off if you prefer not to hear key tones while you are dialling or pressing any keys, including confirmation tones and error tones. *14If you subscribe to a Caller ID service and want to view the caller's information after lifting up the handset to answer a call, turn off this feature. *15The recall/flash time depends on your telephone exchange or host PBX. *16The default setting will be as follows if you select the following regional codes when changing the unit's region setting (page 32): *17To prevent other users from joining your conversations with outside callers, turn this feature on. 29 TG8051_8061FX(e-e). book Page 30 Monday, April 25, 2011 11:42 AM Programming Special programming Alarm An alarm sounds at the set time for 3 minutes once or daily. Important: L Set the date and time beforehand (page 16). 1 2 1 (middle soft key) y72z {r}: Select the desired alarm option. "Once" An alarm sounds once at the set time. "Daily" An alarm sounds daily at the set time. Go to step 4. Using the phonebook's category feature (page 22), you can also select categories of callers whose calls override night mode and ring the handset (Caller ID subscribers only). Important: L You must store the phone number with an area code in the call barred list. From the caller list: 1 {3} (y) 2 {r}: Select the entry to be barred. s MsI 3 {r}: "Caller Barred" s M 4 {r}: "Yes" s M s {ic} By entering phone numbers: 1 1 (middle soft key) y217 s m 2 Enter the phone number (24 digits max. ). s M L To erase a digit, press ^. 3 Note: L You can also select the categories in step 2 as follows: Press 1 to 9. s M Changing the handset name Each handset can be given a customised name ("Bob", "Kitchen", etc. ). This is useful when you make intercom calls between handsets. You can also select whether or not the handset name is displayed in standby mode. If you select "Yes" without entering any handset name, "Handset 1" to "Handset 6" is displayed. 3 {ic} 1 2 3 4 5 1 (middle soft key) y1z4 Enter the desired name (max. s M 2 times {ic} Viewing/editing/erasing bar call numbers 1 2 3 1 (middle soft key) y217 {r}: Select the desired entry. To edit a number: ~ s Edit the phone number. s M s {ic} To erase a number: W s {r}: "Yes" s M s {ic} Incoming call barring (Caller ID subscribers only) This feature allows the unit to reject calls from specified phone numbers that you do not want to answer such as junk calls. [. . . ] Contact your DSL/ADSL provider for details. L The unit could not connect to the SMS message centre. Confirm that the correct SMS message centre numbers are stored. Confirm that SMS is turned on (page 37). [. . . ]