User manual TOSHIBA H-240-QQ

[. . . ] Table of Contents TABLE OF CONTENTS 1. INTRODUCTION 1. 1 1. 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . APPLICABLE MODEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ACCESSORIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page l- 1 l- 5 l- 5 2- 1 22221 1 1 2. [. . . ] p*- - - Enter the title No. I - Enter the title. (Refer to Pages 3-2 and 6-2. ) Table 3: Default title of nutrition facts + The title of additional information (See NOTE 1. ) area 1. +-The +-The + title of additional information title of additional information The title of additional information area 2. area 4. (See NOTE 1 and 2. ) t-The title of additional information area 5. + The title of additional information area 6. ! The title of additional information The title of additional information The title of additional information area 7 and 8. PROGRAMMING PROCEDURES 6. 8 SElTlNG TITLE OF NUTRITION FACTS NOTES: 1. The fit/es of the addil onal information areas are displayed in the following positions. Additional Information Area Additional Information Area 7 Additional Information Area 8 Additional Information Area 9 Additional Information Area 10 Additional Information Area 11 Additional Information Area 12 Displayed position No. 26, column 12 to 21 Additional Information Area Additional Information Area 1 Displayed position No. 18 column 1 to 18 1 Additional Information Area 5 1 Additional Information Area 6 No. 21 column 1 to 18 2. Set a colon `I' at the column 20 and a `g' or `mg' at the column entering titles into No. 21. 21 and 22 when 6. 9 SETTING INGREDIENT CARE INSTRUCTIONS MESSAGE/COUPON/ /DAY GLOW MESSAGE and 29 characters by 22 lines of coupon and Up to 45 characters by 32 lines of ingredient message, care instructions are set in the following procedure. y$pqt. Enter the PLUM. (Refer to pages 3-2 and 6-2) Instruction) I MODE - - p* RIN CHANGE LD%d EG. When customer label 2 or 3 is selected characters per line is 41. number of For the florist machine, coupon messages or care instructions can be enlarged to a two-line size within 16 characters by 71 lines. The display shows as follows when setting enlarged messages. jl 3. Though you can set characters printed. N: Line No. is every other number outside of the above range, those characters are not A maximum of 7 or 14 characters for Day Glow message as the ingredient message. A maximum of 45 characters or 14 characters can be printed. (X4, 1 line: 7 characters, X2, 2 or 3 fines: 14 characters) can be set in the same way can be set, however, only 7 6-13 6. PROGRAMMING PROCEDURES 6. 10 SElTING NUTRITION INFORMATION 6. 10 SETTING NUTRITION INFORMATION total number of characters Nutrition information and caloric intake are set in the following procedure. However, Serving Size consists of a maximaum of 13 characters. including title characters must not exceed 25. PROG. + NEXT 4 , p* NUTRITION Enter the PLU# (max. 6 dig. ) NEXT Or - A I Enter the Serving Size. [. . . ] Avoid areas where they would be exposed to direct sunlight, high temperature, high humidity, dust or gas. For further information please contact your local distributor or your label manufacturer. l 12- 1 13. ERROR MESSAGE TABLE When an error message appears on the LCD display, follow the instructions below. If you cannot solve the problem with the following solution instructions, do not attempt further trouble shooting by yourself. Turn the power off, unplug the printer, then contact your Authorized Service representative for assistance. [. . . ]