User manual TOSHIBA IK-TF1

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. USER-INSTALLER CAUTION: Your authority to operate this FCC verified equipment could be voided if you make changes or modifications not expressly approved by the party responsible for compliance to Part 15 of the FCC Rules. This Class A digital apparatus complies with Canadian ICES-003. [. . . ] Result displayed AWB OK AWB NG LEVEL LOW AWB NG LEVEL HIGH AWB NG C. TEMP LOW Meaning Automatic white balance adjustment finished correctly. Automatic white balance adjustment cannot be performed because the video level is too low. Automatic white balance adjustment cannot be performed because the video level is too high. Automatic white balance adjustment cannot be performed because the color temperature is too low. If the C. TEMP is set to 5600K, set to 3200K. If the message appears with the C. TEMP set to 3200K, change the illumination or use a color temperature conversion filter. Automatic white balance adjustment cannot be performed because the color temperature is too high. If the C. TEMP is set to 3200K, set to 5600K. If the message appears with the C. TEMP set to 5600K, change the illumination or use the color temperature conversion filter. Automatic white balance adjustment cannot be performed because the shutter speed mode is E. TRG mode. When the setting is performed, select the menu of the item to be set. 7. 1 Using the Menus When the power is turned on, the normal screen showing only the video signal appears. Change the output to each screen (video signal output, Index menu, and menus) by using the [DISP], [PAGE], [MENU UP], and [MENU DOWN] buttons. * A menu is selected when pushing the [PAGE] button after moving the "" on the screen by the [MENU UP], [MENU DOWN] button while the Index menu is displayed. POWER ON Video signal output DISP PAGE Index menu DISP DISP PAGE Menues PAGE SHUTTER MANU SS E. TRG RR PAGE GAIN MANU OFF PAGE WHT BAL AWB MANU PROCESS SHAD. OFF SYNC INT EXT PAGE OPTION BAUD RATE 12 7. 2 Menus · Select the menu to change the setting by referring to the item "7. 1 Using the Menus". ) · When the [MENU UP], [MENU DOWN] buttons are pushed, the "" on the screen moves up and down. Move the "" to the item whose setting you wish to change. Note: When performing the mode setting in the menu display while selecting ON in "PART" (Partial Read: refer to page 30) and E. TRG in "MODE", the screen display and camera operation switch to normal mode. After close the MENU, they return to previous mode. ( 1 ) SHUTTER (Electronic shutter) The electronic shutter has three modes; MANU (Manual), SS (Synchro. Move the "" to "MODE" and push [DATA UP], [DATA DOWN] button to select the desired mode among "MANU", "SS", "E. TRG". [. . . ] Instruction Manual (Owner's Manual): You should read the Instruction Manual (Owner's Manual) thoroughly before operating this Product. Before seeking warranty service, you should check the troubleshooting guide in the Instruction Manual (Owner's Manual) and follow the instructions to correct the problem. Your Responsibilities This Limited Warranty is subject to the following conditions: 1. You must provide the bill of sale or proof of purchase at the time that warranty service is required. [. . . ]