User manual TOSHIBA IK-53N

[. . . ] CCD CAMERA INSTRUCTION MANUAL Warranty supplied IK-53N IK-52N For Customer Use Enter below the Serial No. which is located on the bottom of the camera. Retain this information for future reference. Model No. : IK-53N IK-52N Serial No. : 2. [. . . ] · Do not put the product in direct sunshine and/or high temperature. The temperature inside the product may cause fire. · Avoid setting in humid, smoky, vaporized or dusty places. A fire or an electric shock may occur in such places. This may cause fire and/or electric shock. · Do not point the lens directly at the sun and/or intensive light such as direct sunlight, etc. Focusing of the light may cause injury of eye and/or fire. · Do not put the product in your mouth or swallow any parts. This may cause suffocation and/or injury. · Ask your dealer to perform a periodical check and internal cleaning (approx. Dust inside the product may cause fire and/or trouble. For check and cleaning cost, please consult your dealer. *1: *2: *3: *4: *4 *4 75 ON HD/VD INT EXT OFF SHT TRG FRM 28 0. 5 [0. 02"] M. G [Top] 4 [Bottom] 1 Lens mount (C mount) This is used to mount a C-mount type lens or optical equipment. 2 Camera fixing reference hole (top side) 3 Camera fixing reference hole/Tripod fixing metal screw hole (bottom side) 4 Camera fixing reference hole/Tripod fixing metal screw hole (bottom side) The shutter speed setting is indicated in Fig. The normal shutter 6, 7 is either ON or OFF. In the external trigger mode, the camera is automatically set to field accumulation regardless of the switch position. 4. 1 [0. 16"] 6. 3 [0. 25"] 1 2 3 4 5 6 7 8 9 0 20 0. 1 [0. 79"] When the mass of lens exceeds 300g, fix the camera at the side of the lens. 4 Field accumulation/Frame accumulation (MODE SELECT switch bit 9) This switch selects the potential accumulation mode of the CCD. OFF: Field accumulation, ON: Frame accumulation 5 75 terminal switch setting (Terminal of external synchronizing HD/VD input signal) Set to ON to terminate the external synchronizing HD/VD, or to OFF when termination is not required. 6 HD/VD signal input/output selector switch setting Set to INT to output the HD/VD signal from the camera, and set to EXT to input an external HD/VD signal to the camera. 7 Gain selector switch setting (MODE SELECT switch bit 0) This switch selects the modes OFF (fixed) or ON (manual). For the setting positions, refer to the Fig. The factory setting is OFF (fixed). 4- R 1 (16. 5 [0. 65"]) 3-M3 depth 3 [0. 12"] 4-M2 depth 3 [0. 12"] 5. Standard Connection Image processor Lens IK-53N IK-52N Camera cable (option) Disclaimer We disclaim any responsibility and shall be held harmless for any damages or losses incurred by the user in any of the following cases: 1. [. . . ] · Handling of the protection cap. Keep the protection cap away from children. Children may put them into mouth or swallow them accidentally. The protection cap protects the image sensing plane when the lens is removed from the camera, do not throw away. [. . . ]