User manual TOSHIBA IK-6400A

[. . . ] Use only with stand, tripod, bracket, or table recommended by the manufacturer, or sold with the video product. Any mounting of the product should follow the manufacturer's instructions, and should use a mounting accessory recommended by the manufacturer. 9. Ventilation This video product should never be placed near or over a radiator or heat register. [. . . ] Safety Check Upon completion of any service or repairs to this video product, ask the service technician to perform safety checks to determine that the video product is in proper operating condition. FIELD INSTALLATION MARKING: WORDED : THIS INSTALLATION SHOULD BE MADE BY A QUALIFIED SERVICE PERSON AND SHOULD CONFORM TO ALL LOCAL CODES. Note : The camera is indoor used INFORMATION This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses , and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipmetn in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. USER-INSTALLER CAUTION : Your authority to operate this FCC verified equipment could be voided if you make changes or modifications not expressly approved by the party. 1-1 1. COMPONENTS: (1) Camera (2) Accessories (a) Lens Connector (b) Instruction Manual (c) Lens Cap 1 1 1 1 (E4-191J-100(M)) 2. CONNECTION AND OPERATIONS Notes on connecting Power plugs of connected equipment must be disconnected before installations. A 75-ohm coaxial cable (3C-2V or 5C-2V) is required for standard connection. For details of wiring and operation of equipment to be connected, refer to their operation manuals. Lenses, coaxial cables for video signals and the power cord are not supplied with the camera. MONITOR TV CAMERA AC 24V CAUTION : Never input 24V AC and 12V DC at the same time. Do not overload power supply Since this camera uses 24V AC UL Listed Class 2 power supply or 12V DC power supply, it should be connected to a power supply that allows for at least 5w consumption. 3. Line-Lock control Matching the vertical synchronization with the power frequency is called the Line-Lock. This function is activated when the LL switch is set to ON. ON OFF LL 4. LENS Back-Focus Adjustment Back-Focus is adjusted at the factory to accommodate most standard lenses. However, at times, slight adjustment to the camera back-focus is necessary. Focus Lock Screw When two or more cameras are switched by video switcher for viewing by a monitor TV, the vertical sync. phase can be locked with the power frequency, and a stable vertical sync. is obtained without being disturbed at the time of switching. CAMERA1 MONITOR TV Mount the Lens to the camera first. Then rotate the Focus ring until a clear image is achieved. Afterwards, tighten the Focus Lock Screw. Note Focus ring When the lens weight is more than 1 kg (2. 2 lbs), support it on the lens side rather than rely on screw that fix the camera to the tripod. IRIS CAMERA2 VIDEO SWITCHER TO AC 24V UL Listed Class 2 power supply This camera supports two types of auto-iris lens: Video-type and DC (direct drive) types. [. . . ] Otherwise, the quality of images may deterlorate or internal parts may be affected. Special care is required to use the camera at high temperature and humidity. Should you notice any trouble If any trouble occurs while you are using the camera, turn off the power and contact your dealer. If you continue to use the camera when there is something wrong with it, the trouble may much worse and an unpredictable accident may occur. 50% 50% 8. [. . . ]