User manual TOSHIBA IK-64WDA

[. . . ] Power Sources This video product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your location, consult your product dealer. 11. Power-Cord Protection Power-Supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, screws and the point where they exit from the product. 12. Lightning For added protection for this video product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the power supply and cable system. [. . . ] Refer all servicing to qualified service personnel. 16. Damage Requiring service Disconnect this video product from the power supply and refer servicing to qualified service personnel under the following conditions. When the power-supply cord or plug is damaged. If liquid has been spilled, or objects have fallen into the video product. If the video product has been exposed to rain or water. If the video product does not operate normally by following the operating instructions in the instruction manual. Adjust only those controls that are covered by the instruction manual as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the video product to its normal operation. If the video product has been dropped or the cabinet has been damaged. When the video product exhibits a distinct change in performance-this indicates a need for service. The lightening flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. 17. Replacement Parts When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer with the same characteristics as the original part. If you still have vertical fluctuation, adjust the V. PHASE controller. Video IRIS Lens IRIS terminal pin 1. GND VIDEO position Direct Drive IRIS Lens 1. iver-(g) DC position Note V. PHASE CONTROLLER IRIS Switch The camera is synchronized to the power frequency of 60 1 Hz covering a normal fluctuation of the power frequency. However, the camera may not cover a large fluctuation caused from the power generated by an engine generator, etc. It takes about 10 seconds or more until a stable synchronization is obtained after the power is turned on. This normal, because several seconds are required to stabilize the camera against power noise. 1-2 5. AUTOMATIC ELECTRONIC SHUTTER (AES) Exposure time is controlled automatically within a range of 1/60 sec. to obtain an adequate signal when the back panel switch is turned to AES. When the back panel switch is turned to VIDEO or DC, the exposure time is fixed 1/60 sec. 7. NOTES ON USE AND INSTALLATION Do not aim the camera at the sun Do not aim the camera at the sun or point it at sun even if you are not shooting. Do not shoot intense light Intense light such as a spotlight may cause a bloom or smear. A vertical stripe may appear on the screen. [. . . ] If the camera gets wet, turn off the power and contact your dealer. Install the camera Where no video noise appears If cables are wired near electric lighting wires or a TV set, noise may appear in images. In this event, relocate cables or reinstall equipment. When the automatic electronic iris and the auto iris lens is used, the exposure adjustment is automatically performed so that a best picture is obtained at a monitor zone of about 60% in horizontal and about 60% in vertical direction. This function is effective when a strong light enters the portion other than this zone and auto iris lens closes and darkens the area to view. (Monitor screen) Check the ambient temperature and humidity Avoid using the camera where the temperature is hotter or colder than specified. Otherwise, the quality of images may deterlorate or internal parts may be affected. [. . . ]