User manual TOSHIBA IK-7200A

[. . . ] INSTRUCTION MANUAL 11 Read Instructions IMPORTANT SAFEGUARDS 121 Lightning For additional protection on this video product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the power supply and cable system. This will prevent damage to the video product due to lightning and power-line surges. If lightning occurs, do not touch the unit or any connected cables in order to avoid electric shock. Read all the safety and operating instructions before operating the product. CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK. [. . . ] The image is displayed when the camera is powered on. 31. 5 inches (800mm) Protection of Personal Information Images taken by the camera that reveal the likeness of an individual person may be considered personal information. To disclose, exhibit or transmit those images over the internet or otherwise, consent of the person may be required. 12V DC power supply GND Usage Limitation The product is not designed for any "critical applications. " "Critical applications" means life support systems, exhaust or smoke extraction applications, medical applications, commercial aviation, mass transit applications, military applications, homeland security applications, nuclear facilities or systems or any other applications where product failure could lead to injury to persons or loss of life or catastrophic property damage. Accordingly, [Toshiba/TAIS] disclaims any and all liability arising out of the use of the product in any critical applications. -3- Do not adjust this screw This Power Connector is provided as an accessory. Recommended power cord is a minimum wire size of 18 AWG. AGC/BLC Selection Switch -4- Do not overload power supply The recommended power supply for this camera is 9 watts minimum at 12V DC. -5- 3. Make sure that the cap has been tightly secured to the camera using a screwdriver. (1) Backlight Compensation (BLC) The exposure is automatically adjusted so that the best picture is obtained at a monitor zone of about 50% in the horizontal and about 50% in the vertical directions. (2) Auto Gain Control (AGC) Camera maximum gain can be selected High (30dB) or Low (24dB). The factory setting is "High". If the image is noisy in low-light, change this switch to "Low". 3-4 Day / Night Function This camera is equipped with near-infrared LEDs (IR LED) of 850nm. The LEDs turn on automatically when it becomes dark. (The human eye cannot clearly see the light of the LEDs. ) This camera is able to clearly produce monochrome images at a range of less than 82 feet. -7- 4. NOTES ON USE AND INSTALLATION · Do not aim the camera at the sun · Do not shoot intense light Never aim the camera at the sun even with the camera power off. Intense light such as a spotlight may cause a bloom or smear. A vertical stripe may appear on the screen. Do not drop the camera or subject it to intense vibration. Do not touch the internal parts of the camera other than the parts specified. Install the camera where the camera can be used indoors or outdoors according to IP66 code. If the camera was dropped in the water, turn off the power and contact your dealer. If cables are wired near electric lighting wires or a TV set, noise may appear in images. In this event relocate cables or reinstall equipment. [. . . ] If technical support determines that the unit is defective, an RMA will be issued with return instructions for repair. Securely pack the Product in the original carton and external shipping pack, include a letter explaining the problem with a copy of the bill of sale or proof of purchase. Prepay all transportation and insurance costs. Your Responsibilities: This Limited Warranty is subject to the following conditions: 1. [. . . ]