User manual TOSHIBA IK-CU51

[. . . ] INSTRUCTION MANUAL CAMERA CONTROL UNIT IK-CU51 For Customer Use Enter below the Serial No. which is located on the bottom of the cabinet. Retain this information for future reference. Model No. : IK-CU51 Serial No. : INFORMATION This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Automatically traces variations of color temperature and adjusts the white balance. SET Adjust white balance by pressing "UP" button on the camera control unit while shooting a white object. Measurement accuracy is higher than AUTO mode. This mode is effective when shooting under less variations of color temperature. MANU Adjust R (red) and B (blue) levels on the control unit while shooting a white object. Measurement accuracy is higher than SET mode. This mode is effective for users desiring specific color temperature, also effective when shooting under the least variations of color temperature. Adjustment will be made by viewing monitor or vector scope. Outline Features Notes Under poor illumination, white balance may not be correct. 11 (1) White balance adjustment in modes other than AUTO (1. 1) White balance adjustment in SET mode 1 Set the WB switch to "SET" position. 2 Shoot a white object to fill entire screen and press the UP button ( sec. , ) for about 2 3 When the white balance adjustment completes, the letters "WB SET" blinking at the upper right of the screen changes to "WB OK" and then turns off. If the "WB NG" is displayed, it shows the white balance is out of the adjustment range. This is caused by the object not being white enough, or the video level is set too high or too low even if the white object is shot. Shoot the white object or set the video level correctly. Note: · With the screen menu displayed, the UP button is used for moving the cursor or modifying the data. To activate the SET mode by pressing the UP button, turn off the screen menu. (1. 2) White balance adjustment in MANU mode 1 Set the WB switch to "MANU" position. 2 Shoot the white object and adjust the white balance by adjusting the white balance adjust controls "R" and "B" with the screwdriver while observing the monitor or vector scope. 6. 3 FUNC LOCK Switch The FUNC LOCK switch protects settings even if a switch is accidentally pressed after setting. When the FUNC LOCK switch is ON, only the following functions are available. POWER switch (ON/OFF) FILE (A/B) in menu Settings will not be changed even if the other switches are operated. In the menu screen, all except FILE and END are displayed in black letters (white when the FUNC LOCK switch is OFF) and "FUNCTION LOCK ACTIVE" blinks to indicate that the FUNC LOCK switch is ON. FILE SHUTTER PEDESTAL SYNC AREA WB-OFFSET A AUTO 00 INT LINK:1 00 INIT. END FUNCTION LOCK ACTIVE PUSH FUNC TO SELECT 7. MODE SETTING BY ON SCREEN DISPLAY Setting while monitoring the menu on the monitor screen is possible. The following seven items can be set. 1 Scene file 2 Electronic shutter (AUTO/MANUAL), backlight correction 3 Pedestal level 4 Phase matching in external synchronization (horizontal/subcarrier synchronization) 5 White balance, auto electronic shutter, AGC measurement area 6 White balance offset 7 Scene file factory setting Main Menu Press the FUNC button to display the menu. Move the cursor to a desired item by moving the cursor up or down using the UP and DOWN buttons, and set an item by pressing the FUNC button. [. . . ] Do not use benzine, alcohol, thinner, household detergents, chemically treated cloths, etc. If used, coating and printed letters may be discolored. When cleaning the lens, use a lens cleaning paper, etc. q Avoid using or storing the camera in the following places: If the camera or the cables are located near power utility lines or a TV, etc. undesirable noise may appear on the screen. [. . . ]