User manual TOSHIBA IK-DF01A

[. . . ] INSTRUCTION MANUAL CCD COLOR CAMERA IK-DF01A Please read this manual thoroughly before use, and keep it handy for future reference. Record in space provided below the Model No. as found on the label on the bottom of this unit. Retain this information for future reference. TABLE OF CONTENTS Important safeguards 1. Features & Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. USER-INSTALLER CAUTION : Your authority to operate this FCC verified equipment could be voided if you make changes or modifications not expressly approved by the party. -2- 1. FEATURES & DESCRIPTION : IK-DF01A has following function. (1) Quick install Design- you can manually set the camera direction. (2) Built in vari-focal lens with auto-iris Focal length 2. 8~5. 8mm (3) Incorporated 1/4type CCD image sensor gives high resolution and excellent sensitivity 480 lines horizontal resolution 0. 5 lx minimum illumination with smoke cover (4) 50dB Signal-To Noise Patio (5) Power supply- AC24V or DC12V - This camera automatically detects the power. (6) BLC, AGC, and Line-Lock (AC24V) 2. Cautions : (1) In order to protect the camera, avoid placing or using it under direct sunlight, rain or dust. (2) Avoid touching the CCD sensor with your fingers. If necessary, use a soft cloth moistened with alcohol to wipe off any dust. (3) When the camera is not in use, keep the lens cap attached to protect the CCD sensor. (5) Avoid shooting the camera at intense light. Intense light such as a spotlight may cause a bloom or smear. A vertical stripe may appear on the screen. (6) Install the camera away from video noise. If cables are wired near electric lighting wires or a TV set, noise may appear in images. In this event, relocate cables or reinstall equipment. 3. Components : (1) Camera 1 (2) Accessories (a) Instruction Manual 1 (b) Installation Screw 2 -3- 4. PART NAMES & FUNCTIONS : Knockout Cut with a knife or scissors and insert the cables through the knockout so the cables will not pinched when installed. Power Input Cable Connect the power cable to AC24V or DC12V. (RED:+12, Black:GND) VIDEO Cable (BNC Tap) Connect the Video Cable to a monitor or video device. The image is outputted when powered on. Zoom Lever "Bottom" mark The "Bottom" mark indicates the lens position. The "Bottom" mark should be on the top when installing in a ceiling. Its screw design allows locking capability. Focus Lever Adjusts the image into focus. [. . . ] · Never touch internal parts Do not touch the internal parts of the camera other than the parts specified. · Do not splash water on the camera Install the camera where the camera can be kept dry. If the camera gets wet, turn off the power and contact your dealer. · Check the ambient temperature and humidity Avoid using the camera where the temperature is hotter or colder than specified. [. . . ]