User manual TOSHIBA IK-DF02A

[. . . ] INSTRUCTION MANUAL DOME CAMERA ZEIM-4000100G A. 1 IK-DF02A Please read this manual thoroughly before use, and keep it handy for future reference. Record in space provided below the Model # and the Serial # as found on the label on the bottom of this unit. Model # IK-DF02A Serial # Retain this information for future reference. TABLE OF CONTENTS 1. IMPORTANT SAFEGUARDS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . FEATURES AND DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Line Lock is available with 24V AC only. V Phase ADJ Adjust the phase difference between this camera and other cameras in Line Lock mode. Tilt ADJ Screws Turn the screws to adjust the lens tilt angle. Fasten and lock them after completing the adjustment. MON (Monitor Out) When installing the camera, it is available to check the image with monitor out harness wire. -5- 4. CONNECTIONS Notes on connecting · Power plugs of connected equipment must be disconnected before camera installation. · A 75-ohm coaxial cable with connector (3C-2V or 5C-2V) is required for standard connection. · For details of wiring and operation of equipment to be connected, refer to their operation manuals. To remove the cover, rotate the cover counter clockwise. Pull on the cover to remove it from the base. Move "Lock Pin" with a screwdriver from "Unlock" position to "Lock" position. Align the "Unlock-button" with position "P". Rotate the cover clockwise to lock the cover to the base. Cover Cover Removal with the Tamper Resistant Feature Enabled Caution: Pulling on the cover with excessive force can cause the inner connector to break. Unlock the cover by pressing the "Unlock-button" with a screwdriver. While the "Unlock-button" is depressed rotate the cover counter clockwise. Pull on the cover to remove it from the base. Cover Screwdriver -8- To Determine Which Set of Mounting Holes to Use There are two different sets of mounting holes (i and ii). The set to use depends if the camera is being mounted to a switch box or not and to a wall or ceiling. Note: When determining the orientation of the switch box take into consideration the viewing angle of the unlock-button. If possible, conceal the unlock-button. Mounting Holes (i) · Installation to a wall or ceiling. (Refer to section 5-1-2. ) · Installation to a switch box positioned normally on a wall. (Refer to section 5-1-3 (i). ) · Installation to a switch box attached to a ceiling. (Refer to section 5-1-3 (i) for switch box orientation. ) Upside TOP mark This mark is supposed to be upside. Wire Hole Mounting Holes (ii) · Installation to a switch box positioned sideways on a wall. (Refer to section 5-1-3 (ii). ) · Installation to a switch box attached to a ceiling. (Refer to section 5-1-3 (ii) for switch box orientation. ) -9- 5-1-2. Installation to a Wall or Ceiling 1. 81(46) Upside 0. 71(18) Wire Access Hole 0. 21(5. 3) 3. 29(83. 5) 1. 65(42) Screw x4 Dimensions: inch (mm) To mount the camera directly on the wall or ceiling. [. . . ] How to Obtain Warranty Service Step-by-step Procedures: To obtain warranty service. Contact Toshiba at (877) 855-1349 to first verify operation or installation assistance. If technical support determines that the unit is defective, an RMA will be issued with return instructions for repair. Securely pack the Product in the original carton and external shipping pack, include a letter explaining the problem with a copy of the bill of sale or proof of purchase. [. . . ]