User manual TOSHIBA IK-DP30A

[. . . ] INSTRUCTION MANUAL ZEIM-4000008G A. 1 DOME CAMERA IK-DP30A Please read this manual thoroughly before use, and keep it handy for future reference. Record in space provided below the Model No. and the Serial Number as found on the label on the bottom of the camera. Retain this information for future reference. TABLE OF CONTENTS IMPORTANT SAFEGUARDS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Features and description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] At telephoto settings, the pan and tilt speeds will be slower to keep the image from moving too fast on the monitor. Menu MAIN MENU <CAMERA SETUP> <PAN/TILT SETUP> <PRESET TITLES> <OTHERS> EXIT PAN/TILT MENU AUTO FLIP ON PROPORTIONALP/T ON SCAN LIMIT STOPS OFF MANUAL LIMIT STOPS OFF PARK TIME MIN 0MIN AUTO PATROL P1 OFF SCAN SPEED 5DEG. /S SCAN TILT ANGLE 30DEG. STOP TIME 10SEC MAX SPEED 400DEG/S To enable PROPORTIONAL P/T: 1. Enter the preset command to access the main menu. Refer to section 6. 1 for the controller model and preset command. Position the cursor ( ) next to PAN/TILT SETUP and press the OPEN button to access the Pan/ Tilt menu. Position the cursor next to PROPORTIONAL P/T and press the OPEN button to move the cursor to the right. Move the joystick up or down to select ON or OFF. To accept the selection, press the OPEN button or to cancel the selection, press the CLOSE button. 6. 8. 3 SCAN LIMIT STOPS When a Scan Limit Stop is reached during random, frame or auto scan, the dome camera will reverse direction. A Left Scan Limit Stop and Right Scan Limit Stop can be set. The limit stops must be greater than 10 degrees apart. Menu MAIN MENU <CAMERA SETUP> <PAN/TILT SETUP> <PRESET TITLES> <OTHERS> EXIT PAN/TIL T MENU AUTO FLIP ON PROPORTIONALP/T ON SCAN LIMIT STOPS OFF MANUAL LIMIT STOPS OFF PARK TIME MIN 0MIN AUTO PATROL P1 OFF SCAN SPEED 5DEG. /S SCAN TILT ANGLE 30DEG. STOP TIME 10SEC MAX SPEED 400DEG/S - 19 - To enable SCAN LIMIT STOPS: 1. Enter the preset command to access the main menu. Refer to section 6. 1 for the controller model and preset command. Position the cursor ( ) next to PAN/TILT SETUP and press the OPEN button to access the Pan/ Tilt menu. Position the cursor next to SCAN LIMIT STOPS and press the OPEN button to move the cursor to the right. Move the joystick up or down to select ON or OFF. To accept the selection, press the OPEN button or to cancel the selection, press the CLOSE button. Set SCAN LIMIT STOPS to ON and exit menu. Position the camera for the LEFT LIMIT STOP. [. . . ] How to Obtain Warranty Service Step-by-step Procedures: To obtain warranty service. Contact Toshiba at (877) 855-1349 to first verify operation or installation assistance. If technical support determines that the unit is defective, an RMA will be issued with return instructions for repair. Securely pack the Product in the original carton and external shipping pack, include a letter explaining the problem with a copy of the bill of sale or proof of purchase. [. . . ]