User manual TOSHIBA IK-HR2D

[. . . ] CMOS COLOR CAMERA INSTRUCTION MANUAL IK-HR2D For Customer Use Enter the Serial # (which is located on the bottom of the cabinet) below. Retain this information for future reference. Model # Serial # IK-HR2D FCC NOTICE This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] The character AWB blinks on the screen when the AWB starts. The character AWB stops blinking when the AWB finishes, and the result is displayed for approx. 1 second. 10 Display AWB OK AWB NG LEVEL LOW AWB NG LEVEL HIGH AWB NG C. TEMP LOW Meaning Automatic white balance adjustment finished correctly. Automatic white balance adjustment cannot be performed because the video level is too low. Adjust the video level by increasing the illumination or opening the lens iris. Automatic white balance adjustment cannot be performed because the video level is too high. Adjust the video level by decreasing the illumination or closing the lens iris. Automatic white balance adjustment cannot be performed because the color temperature is too low. If the C. TEMP is set to 5600K, set to 3200K. If the message appears with the C. TEMP set to 3200K, change the illumination or use a color temperature conversion filter. AWB NG C. TEMP HIGH Automatic white balance adjustment cannot be performed because the color temperature is too high. If the C. TEMP is set to 3200K, set to 5600K. If the message appears with the C. TEMP set to 5600K, change the illumination or use the color temperature conversion filter. AWB NG Automatic white balance adjustment cannot be performed for other reasons. Such as no white area is included in an object, etc. (2) MANUAL(Manual white balance) Set the MODE to MANUAL on the WHT BAL menu. (Refer to the item "7. 3 (3) WHT BAL (White Balance)". ) Shoot a known white object, set the white balance by adjusting the levels of R GAIN and B GAIN on the menu, confirming with a monitor or a vector scope. (Refer to the item "7. 3 (3) (3. 3) Changing gain in MANUAL mode". ) 11 5 2 Gain When the image is dark even if the lens iris is open, change the gain (video gain) to get the desired video level. For gain adjustment of the unit, MANUAL (Manual), OFF (0 dB) modes are provided. (Refer to the item "7. 3 (2) GAIN (Video gain)". ) (1) MANUAL(Manual gain) Gain adjustment is performed on the GAIN menu. The adjustment range is from 0 to 18dB in 1dB steps. (Refer to the item "7. 3 (2) (2. 1) Changing gain in MANUAL mode". ) (2) OFF Gain is fixed at 0 dB. Note: White, red, green, or blue dots may occur when the gain is increased. This is not a malfunction, just certain characteristics of the CMOS sensor becoming more visible. 5 3 Switching video signal output By turning on the power while the control buttons on the rear panel are pressed, the video signal output of the DVI-D terminal can be switched. [. . . ] You must notify an ASP within thirty (30) days after You discover that the Product does not perform in accordance with specifications during the Limited Warranty period. All warranty servicing of this product must be made by an ISD Authorized Service Provider. You must pack the Product in its original carton using the original packing material, then insert the original carton containing the Product into another carton with additional packing material before shipping the Product to an ASP. DISCLAIMERS: ALL OTHER EXPRESS OR IMPLIED WARRANTIES ON THIS PRODUCT, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY DISCLAIMED. [. . . ]