User manual TOSHIBA M221

[. . . ] 109 4 INSTALLING YOUR TV English Safety Precautions This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken to obtain the best results and for safety to be assured. Please read the points below for your own safety. They are of a general nature, intended to help with all electronic consumer products, and some points may not apply to the goods you have just purchased. DO NOT REMOVE ANY FIXED COVERS AS THIS WILL EXPOSE DANGEROUS AND `LIVE' PARTS. THE MAINS PLUG IS USED AS A DISCONNECTING DEVICE AND THEREFORE SHOULD BE READILY OPERABLE. Do not DO NOT obstruct the ventilation openings of the equipment with items such as newspapers, tablecloths, curtains, etc. [. . . ] Chooses an accented version of the current letter, if applicable. Saves changes and closes the Software Keyboard window. Closes the Software Keyboard window without saving changes. BbCc CC cc Z z RED GREEN YELLOW BLUE BACK 53 CONTROLS AND FEATURES English Network Device Setup External Control Setup This setup allows you to operate a home network-connected your TV from an external device. Media Renderer a b c In the Preferences menu, press B or b to select Network Device Setup and press OK. Press B or b to select Media Renderer Setup and press OK. Press B or b to select Media Renderer, and then press C or c to select On or Off. Media Controller Setup a In the Preferences menu, press B or b to select Network Device Setup and press OK. Preferences 3D Setup Recording Setup Camera Sensor Setup Personal TV Setup REGZA-LINK Setup MHL Setup Network Setup Network Device Setup Media Controller Setup You can limit which DMC can control this TV. If Access Control is enabled, only those DMCs with a check will be allowed to control the TV. a b c d In the Media Renderer Setup menu, press B or b to select Media Controller Setup and press OK. Press B or b to select Access Control and press C or c to select On. Press B or b to select Select Media Controller and press OK. Press B or b to highlight the item you want to select and press OK. To remove the check, press OK again. b c Press B or b to select External Control Setup and press OK. Press B or b to select an option and press OK. · Do not disconnect the power plug when the indicator lamp is lit. · Any changes implemented by the broadcasting station may affect programme scheduling. · Scheduling of multiple consecutive programmes may result in the beginning of each programme not being recorded. · When the "Programme Tracking" for programmed recording is set to "On" and the broadcast time of the scheduled programme overlaps with the start time of timer viewing due to delay, extension, or other causes, timer viewing will be cancelled. · Depending on the situation at the time, not all items can be set or changed. ("X" indicates no setting. ) · Programmed recording cannot take place if the power plug is not connected. · Disconnecting the power plug during recording may result in failure to save the recorded programme. · Changing the USB 2 Port Setup to Media Player will invalidate all previously made programmed recordings (see page 70). a b In the Preferences menu, press B or b to select Network Device Setup and press OK. Press B or b to select Power Control Mode and press C or c to select On or Off. NOTE: · When Wired is selected for the Network type in Network Setup, this feature will be grayed out. · Depending on the device connected to the home network, it may take a while for the TV to turn on. · Depending on the device connected to the home network, this feature may not work. [. . . ] The black bar indicates that the product was placed on the market after August 13, 2005. By participating in separate collection of products and batteries, you will help to assure the proper disposal of products and batteries and thus help to prevent potential negative consequences for the environment and human health. For more detailed information about the collection and recycling programmes available in your country, please contact your local city office or the shop where you purchased the product. Disposal of batteries and/or accumulators The crossed out wheeled dust bin symbol indicates that batteries and/or accumulators must be collected and disposed of separately from household waste. [. . . ]