User manual TOSHIBA M474

[. . . ] CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. CAUTION: VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK DEFEATED. LOCATION: INSIDE, NEAR THE DECK MECHANISM. Caution 1. There are no parts inside you can service. [. . . ] (standard speed) DVC is slow forwarding. (faster than above) DVC is slow forwarding. (faster than above) DVC is fast forwarding. (without picture) DVC is fast reversing. (without picture) DVC is fast reversing. (faster than above) DVC is fast reversing. (faster than above) DVC is in slow reverse playback. DVC is in recording pause mode. Playback Editing DV AB-1234 0:00:00 Function Setup SP 2:00 Now you can operate your DVC with the remote control of this unit. VCR Functions 5 Press [PLAY B] to start playing back the DVC, and find where you want to start dubbing. Press [STOP C] when it comes to the desired start point. Select "Start Rec" using [U / D], then press [ENTER / OK]. The dubbing will start. 6 Others Please also read the operating instructions of your DVC for more information. EN 49 E9NG1BD_EN. book Page 50 Monday, April 7, 2008 5:54 PM To stop dubbing; 1 2 3 Select "Control" using [U / D], then press [ENTER / OK]. Select "DVD" using [U / D], then press [ENTER / OK]. Press [PLAY P], and then press [PAUSE p] where you want to start recording. Press [DVD]. Make sure to select a recording mode using [REC MODE]. (See page 34. ) 50 EN E9NG1BD_EN. book Page 51 Monday, April 7, 2008 5:54 PM 9 Press [DUBBING]. VCR to DVD duplication will start. 8 Press [VCR]. Make sure to select a recording mode using [REC MODE]. (See page 85. ) Rewind or fast forward the tape to the point where you want to start recording. Introduction 10 Press [STOP S] to stop the recording. Note for VCR to DVD duplication: · During duplication, recording will be paused when a signal other than PAL or SECAM is detected. (See "Video Colour System" on page 47 for details. ) · After starting VCR to DVD duplication, the picture may be distorted because of the auto tracking function. Be advised to play back the tape until the picture is stabilised, then set the starting point at which you want to start recording, and start VCR to DVD duplication. · This unit will automatically stop the duplication if playback with no image detected for more than 3 minutes during VCR to DVD duplication. · If the playback sound mode of VCR is set to "STEREO", "LEFT" or "RIGHT", the sound mode upon dubbing is automatically switched to "STEREO". If the playback sound mode is set to "MONO", the sound mode upon dubbing is also "MONO". · If you set "External Input Audio" to "Stereo", the sound is recorded in "Stereo" (Video mode, VR mode and +VR mode). · While in Video mode or +VR mode, if you set "External Input Audio" to "Bilingual", the audio set in "Bilingual Recording Audio" mode is recorded. [. . . ] PBC (Video CD only) (Playback Control) This function enables you to play back interactive software using a menu screen. PCM (Pulse Code Modulation) PCM is a format that converts audio into digital data. It is mainly used for Audio CDs and DAT. This unit can play back sounds as realistic as possible by converting even compressed Dolby Digital and MPEG audio to PCM. [. . . ]