User manual TOSHIBA M67

[. . . ] This will prevent overheating and possible damage to the television. Dusty places should also be avoided. DO NOT REMOVE ANY FIXED COVERS AS THIS WILL EXPOSE DANGEROUS AND 'LIVE' PARTS. THE MAINS PLUG IS USED AS A DISCONNECTING DEVICE AND THEREFORE SHOULD BE READILY OPERABLE. Heat Damage Damage may occur if the television is left in direct sunlight or near a heater. Avoid places subject to extremely high temperatures or humidity. [. . . ] NOTE: If the HDMI cable from connected equipment is changed or HDMI equipment settings are changed Enable REGZA-LINK in the REGZA-LINK setup menu may need to be reset to On. When the REGZA-LINK input source is selected some REGZA-LINK equipment may automatically switch on. The following features are dependent on the connected equipment. For operating information refer to the operation manual for all connected equipment. 36 REGZA-LINK controls (continued), REGZA-LINK menus By activating the Enable REGZA-LINK feature in the REGZA-LINK setup menu individual REGZA-LINK features can then be activated. REGZA-LINK One Touch Play When connected equipment is switched on REGZA-LINK will automatically detect the television through the input selection. If the television is in standby it will be switched on automatically. This feature is selected in the REGZA-LINK setup menu. NOTE: Even if the equipment is showing a menu the television may automatically show the input source. NOTE: This feature is dependent on the connected equipment and television setting. REGZA-LINK PC link This feature automatically adjusts suitable widescreen formats and picture preferences when connected to REGZA-LINK PC. NOTE: This feature is dependent on the connected equipment. Enable REGZA-LINK When Enable REGZA-LINK is set to On it allows the following functions to be enabled by selecting On. REGZA-LINK System Standby This feature automatically switches connected equipment into standby when the television goes into standby and conversely for the television to switch into standby when connected equipment goes into standby. It is selected in the REGZA-LINK setup menu. NOTE: This feature is dependent on the connected equipment and television setting. 1 Press MENU and LINK menu. z or x to select the REGZA- REGZA-LINK Enable REGZA-LINK TV Auto Input Switch TV Auto Power Auto Standby Speaker Preference On On On On TV Speakers REGZA-LINK System Audio Control MENU Back EXIT Watch TV Using the Speaker Preference feature allows the televisions remote control to adjust the volume or mute the sound of the speakers connected to the television via an AV amplifier. If the HDMI connection is capable of 1080p and/or the television is capable of refresh rates greater than 60Hz or supports Deep Color, a Category 2 cable will be required. Conventional HDMI/DVI cable may not work properly with this mode. EIA/CEA-861-D compliance covers the transmission of uncompressed digital video with high-bandwith digital content protection, which is being standardized for reception of high-definition video signals. Because this is an evolving technology, it is possible that some devices may not operate properly with the TV. HDMI, the HDMI logo, High-Definition Multimedia Interface and Deep Color are trademarks or registered trademarks of HDMI Licensing, LLC. MENU Back EXIT Watch TV If the sound is missing select an alternative setting. NOTE: HDMI1 supports digital and analogue sound, HDMI2 and HDMI3 are digital sound only. Certain formats of DVD disk may not output from this TV (32/44. 1/48kHz and 16/20/24 bits are acceptable). 40 Analogue text services ­ setting up, general information, Auto and LIST modes This television has a multi-page text memory, which takes a few moments to load. It offers two Modes of viewing text ­ Auto will display Fastext, if available. LIST will store your four favourite pages. The sub-page you are viewing will be highlighted and, as the television loads any additional sub-pages the colour of the numbers will change, indicating that these pages have been loaded. These sub-pages will remain available to view until another page is chosen or, in normal TV mode, the channel is changed. Selecting Modes The text character set will be automatically chosen by the language setting in the SET UP menu. 1 2 Select Teletext from the FUNCTION menu. or LIST then press EXIT. Navigating Pages using Auto. If Fastext is available four coloured titles will appear at the base of the screen. Auto. Off On Off On 1 EXIT FUNCTION Teletext Panel lock Auto format 4:3 stretch Blue screen Side panel MENU To access one of the four given subjects, press the relevant coloured button on the remote control. [. . . ] If you wish to incorporate parts of the Library into other free programs whose distribution conditions are incompatible with these, write to the author to ask for permission. For software which is copyrighted by the Free Software Foundation, write to the Free Software Foundation; we sometimes make exceptions for this. Our decision will be guided by the two goals of preserving the free status of all derivatives of our free software and of promoting the sharing and reuse of software generally. BECAUSE THE LIBRARY IS LICENSED FREE OF CHARGE, THERE IS NO WARRANTY FOR THE LIBRARY, TO THE EXTENT PERMITTED BY APPLICABLE LAW. [. . . ]