User manual TOSHIBA MAGNIA 7010

[. . . ] Remove two M2. 5x4 black flat head screws and remove the memory cover. Push the memory clips outward and pull the memory module out of the connector on a 30 degree angle. MINI PCI CARD REMOVAL PCI clips M2. 5x4 black torx screws Mini PCI card Mini PCI slot cover 1. Remove two M2. 5x4 black torx screws securing the mini PCI slot cover. Push the mini PCI slot clips outward and pull the mini PCI card out of the connector on a 45 degree angle. Tough Enough for Today's World TOSHIBA FIELD REPLACEABLE UNIT DOCUMENTATION Satellite 1800 Series MODEM REMOVAL M2x4 brass screws TM RJ11 Jack Modem slot cover M2. 5x4 black flat head screw 1. [. . . ] Remove one M2. 5x4 black flat head screw securing the IPS switch cover(touchpad) from the battery compartment. Remove the IPS switch(touchpad) cover from the palm rest. IPS SWITCH REMOVAL COOLING MODULE REMOVAL PJ339 IPS switch cable Membrane switch assy Heat sink plate M2. 5x6 black flat head screws 1. Remove four M2. 5x6 black flat head screws securing the heat sink plate. Disconnect the IPS switch cable from PJ339 on the system board and lift out the membrane switch assembly. Tough Enough for Today's World TOSHIBA FIELD REPLACEABLE UNIT DOCUMENTATION Satellite 1800 Series COOLING MODULE REMOVAL CPU REMOVAL Flat head screwdriver TM Cooling module Fan cable PJ770 CPU lock CPU M2x16 brass screws 3. Remove four M2x16 brass screws securing the cooling module. Disconnect the fan cable from PJ770 from the system board and lift out the Fan module. Silicone grease 5. Slide the CPU lock in the direction of the arrow. Insert a 5mm flat head screwdriver on the top side of the CPU socket and push the socket in the direction of the arrow and lift out the CPU. NOTE: When installing the CPU make sure that a silicone grease is applied before attaching the cooling module. Please refer to FSB-200112 for the complete procedures on how to apply the silicone grease. . CD-ROM/DVD ROM DRIVE REMOVAL CD/DVD-ROM drive Brass washers CD/DVD-ROM drive bracket M2x2 silver screws M2x5. 5 silver screws 1. Lift up the LED board to disconnect it from PJ310 on the system board. Conn holder M2. 5x6 silver screws 1. Remove two M2. 5x6 silver screws securing the conn holder. Lift out the conn holder. SYSTEM BOARD REMOVAL DC-jack harness PJ800 Hex screws Battery harness System board PJ810 M2. 5x4 black flat head screws 3. Disconnect the DC-jack harness from PJ800 on the system board. Remove two hex screws and three M2. 5x4 black flat ehad screws securing the system board. PJ3 Flexible cable 5. Remove the system board by lifting up from the front side as shown above. Disconnect the flexible cable and battery harness from PJ3 and PJ810 on the system board. Tough Enough for Today's World TOSHIBA FIELD REPLACEABLE UNIT DOCUMENTATION Satellite 1800 Series 13. 3" DISPLAY MASK REMOVAL Latch TM FL INVERTER AND 13. 3" LCD REMOVAL LCD module Display mask LCD M2x3 silver screws M2x5 silver screws FL cable Mask seals 1. Remove two mask seals at the bottom corners of the display assembly to expose two screws securing the display mask. Remove two M2. 5x6 black screws securing the display mask. There are 23 latches securing the display mask. Carefully insert your fingers between the display mask and the LCD module and pry open the latches starting from the seven bottom latches, to the five latches on the right and left sides, ending with the six top latches. [. . . ] Remove four M2x3 silver screws securing the left and right LCD brackets. Tough Enough for Today's World TOSHIBA FIELD REPLACEABLE UNIT DOCUMENTATION Satellite 1800 Series 14" DISPLAY MASK REMOVAL Latch TM FL INVERTER AND 14" LCD REMOVAL LCD module M2x5. 5 silver screws Display mask LCD M2x5. 5 silver screws Mask seals LCD/ FL cable M2x5 brass screw Mask seals FL cable FL inverter board Glass tape Mask seals 1. Remove two mask seals at the bottom corners of the display assembly to expose two screws securing the display mask. Remove two M2. 5x6 black screws securing the display mask. There are 23 latches securing the display mask. [. . . ]