User manual TOSHIBA MV13K1W

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. [. . . ] EXAMPLE: Setting the clock to "8:30 AM", 27th (SAT) March, 2004. 1 Press MENU. Press B or A to select option. 2 Press v or w to select "CLOCK SET", then press A. MENU CLOCK SET ON/OFF TIMER AUTO CLOCK STANDARD TIME DAYLIGHT SAVING TIME / / / / MENU ON CLOCK SET ON/OFF TIMER AUTO CLOCK STANDARD TIME DAYLIGHT SAVING TIME / / / MENU ON D EN SO OI LT C AP C T UT P EC IN L E S 1234 7 C A LL O PR G R A M SP R E MC TI RE 1 4 2 5 8 6 W PO ER 3 TV CO RE UN SE TE TR SE SK AR IP CH MO NIT OR 0 9 L E NN NR AU HT C RE 1 O V L NU EE D O R RN ZE TU E R R E C SL EE P C A N C EL M C ME TR DIG AC IT A KIN L G U H + TE C H O V L + IN DE X TR EJ AC K IN EN G P /S AU TIL SE L + EC TE R T RE + W P Y LA ST OP FF 23 4 After setting the clock, date and time starts functioning automatically. 3 Press B or A to set the month, then press w. 4 Set the day, year and time as in step 3, then press ENTER. ENTER 8 : 30 AM SAT CLOCK SET MONTH DAY YEAR TIME 3 1(MON) 2004 12:00AM CLOCK SET MONTH DAY YEAR TIME 3 27(SAT) 2004 8:30AM / / / / ENTER/MENU / / / / ENTER/MENU NOTES: After a power failure or disconnection of the power plug, the time display will be lost. In this case, set the present time again if the auto clock did not set correctly. To move cursor backward, press v. 17 5L80301C P10-19 17 20/4/04, 16:26 TV OPERATION 1 To turn on the TV/VCR, press POWER. Adjust the volume level by pressing VOL + or . The volume level will be indicated on the screen by green bars. As the volume level increases, so do the number of bars. If the volume decreases, the number of green bars also decreases. 2 3 Set the TV/CABLE selection to the appropriate position (see page 22). TV - VHF/UHF Channels CABLE - Cable TV Channels VOL VOL + VOLUME 22 VHF/UHF/CABLE CHANNELS C CA LO PT SE IO D N 4 7 C A LL O PR G R A M SP EE D R E MC TI RE R E C SEINP LE UT CT TV VHF 2-13 UHF 14-69 TR DIG AC IT A KIN L G IN DE X TR 1 2 AC K IN G P /S AU TIL SE L RE W PL AY ST OP FF CABLE VHF 2-13 STD/HRC/IRC 14-36 (A) (W) 37-59 (AA) (WW) 60-85 (AAA) (ZZZ) 86-94 (86) (94) 95-99 (A-5) (A-1) 100-125 (100) (125) 01 (5A) 1 4 2 5 8 6 W PO ER 3 IP H KC S AR E S TV M O 0 O R RN ZE TU E R N 9 R TE NT UE O ES CR O IT L E NN NR AU HT C RE R SL EE P C A N C EL O V L M EN U M C H + U TE C H O V L + + EN TE Press Direct channel selection (09) to select the channel. TV mode direct channel selection When the TV/CABLE option is in the TV position, all channels can be instantly selected by using two buttons (for example, to select channel 2, press "0", then "2". If you press only "2", channel selection will be delayed for a few seconds). For channels 10 and above, press the 2 digits in order. CABLE mode direct channel selection 0 1 2 When the TV/CABLE option is in the CABLE position, channels can be selected as follows: TO SELECT CABLE CHANNELS: 1-9 Press "0" twice, then 1-9 as needed. In this case, adjust the antenna for better reception or use an outdoor antenna. When activating the closed captioned decoder, there will be a short delay before the closed captioned text appears on the screen. Closed captioned TV programs can be recorded and played back on a VCR with the closed captioned text intact. The closed captioning text will disappear during cue, rewind and pause modes or if the VCR tracking is not adjusted properly. Closed captioned text is only displayed in locations where it is available. If the call display is on, the closed captioning text will not appear. 20 5L80301C P20-33 20 20/4/04, 16:26 WHAT IS CLOSED CAPTIONING?This television has the capability to decode and display closed captioned television programs. Closed captioning will display text on the screen for hearing impaired viewers or it will translate and display text in another language. CLOSED CAPTIONING WITH A VCR Closed captioned programs can be recorded and played back on a VCR with the closed captioned text intact. The closed captioned text will disappear during cue (fast forward search), review (eewind search) and pause modes or if the VCR tracking is not adjusted properly. TO VIEW CLOSED CAPTIONS Press CLOSED CAPTION on the remote control to switch between normal TV and the two closed caption modes (captions and full screen text). [. . . ] During this period TACP will replace a defective part without charge to you, except that if a defective part is replaced after ninety (90) days from the date of original retail purchase you pay labor charges involved in the replacement. You must also deliver the entire product to a TACP Authorized Service Station. You are responsible for all transportation for the set to and from the Service Station. Limited Two (2) Year Warranty of Picture Tube TACP further warrants the picture tube in this product against defects in materials or workmanship for a period of two (2) years after the date of original retail purchase. During this period, TACP will replace a defective picture tube without charge to you except that if a defective picture tube is replaced after ninety (90) days from the date of the original retail purchase, you pay labor charges involved in the replacement. [. . . ]