User manual TOSHIBA NVR8-X HARDWARE MANUAL

[. . . ] NVR Network Video Recorder Hardware Manual model no. NVR8-X NVR16-X Please carefully read these instructions before using this product. Save this manual for future use. 1 ii SurveillixTM NVR Hardware Manual iii SurveillixTM NVR Hardware Manual Manual Edition 27891AB ­DECEMBER 2006 Printed in USA No part of this documentation may be reproduced in any means, electronic or mechanical, for any purpose, except as expressed in the Software License Agreement. Toshiba shall not be liable for technical or editorial errors or omissions contained herein. The information in this document is subject to change without notice. THE INFORMATION IN THIS PUBLICATION IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. [. . . ] Object and Liquid Entry Points Never insert foreign objects into the NVR unit, other than the media types approved by Toshiba, as they may touch dangerous voltage points or short-out parts that could result in a fire or electrical shock. Never spill liquid of any kind on the product. 11. Accessories Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall, causing serious personal injury and serious damage to the product. viii IMPORTANT SAFETY INSTRUCTIONS 12. Disc Tray Keep your fingers well clear of the disc tray as it is closing. Neglecting to do so may cause serious personal injury. 13. Burden Do not place a heavy object on or step on the product. The object may fall, causing serious personal injury and serious damage to the product. 14. Disc Do not use a cracked, deformed, or repaired disc. These discs are easily broken and may cause serious personal injury and product malfunction. 15. Damage Requiring Service Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions. · · · · When the power­supply cord or plug is damaged. Moisture condensation occurs during the following cases. When you bring the NVR unit directly from a cold place to a warm place. When you use the NVR unit in a room where you just turned on the heater, or a place where the cold wind from the air conditioner directly hits the unit. In the summer, when you use the NVR unit in a hot and humid place just after you move the unit from an air conditioned room. When you use the NVR unit in a humid place. Do not use the NVR unit when moisture condensation may occur. If you use the NVR unit in such a situation, it may damage discs and internal parts. Remove any CD discs, connect the power cord of the NVR unit to the wall outlet, turn on the NVR unit, and leave it for two to three hours. After two to three hours, the NVR unit will have warmed up and evaporated any moisture. Keep the NVR unit connected to the wall and moisture will seldom occur. Notes on Locating Place the NVR unit on a level surface. [. . . ] Refer to your monitor manual for detailed information on how to setup and use it. NOTE: The monitor must be capable of having a screen resolution of 1024 x 768 and display colors of at least 32 Bit POWER SETUP Attach the AC power cable to the rear of the NVR Unit. See Rear Panel Connectors for more information. WARNING: To reduce the risk of electrical shock or damage to the equipment: · · · Do not disable the power grounding plug. [. . . ]