User manual TOSHIBA QOSMIO X770

[. . . ] Contact Gateway about returning defective AC adapters. If the battery charge indicator does not turn blue after three hours, contact Gateway Customer Care at the Web address or telephone number shown on the label on the bottom of your notebook. Warning Caution Replace the power cord if it becomes damaged. The replacement cord must be of the same type and voltage rating as the original cord or your notebook may be damaged. Important 2 Connect the AC adapter to your notebook's power connector. Technical Support See the label on the bottom of the notebook for Customer Care Information. See your hardware guide for important safety, regulatory, and legal information. © 2006 Gateway, Inc. [. . . ] 22 Reconnect all peripheral devices that were connected to the notebook and replace any PC Cards. 24 If the hard drive was sent to you from Gateway with the operating system, applications, and drivers installed, you will see the Windows startup screen. -OR- 12 Pull on the plastic tab to slide the old hard drive away from the connector, then remove the drive. 13 Remove the four screws that secure the hard drive to the hard drive bracket. Screw Screw If you see a blank screen, restart your notebook, then press F11 while your computer is starting. Insert the Operating System Recovery CD/DVD when prompted, then follow the on-screen instructions. Screw Screw Technical Support See the label on the bottom of the notebook for Customer Care Information. See your hardware guide for important safety, regulatory, and legal information. © 2006 Gateway, Inc. Gateway and eMachines are trademarks or registered trademarks of Gateway, Inc. in the United States and other countries. All other brands and product names are trademarks or registered trademarks of their respective companies. 2 www. gateway. com Replacing the Keyboard Replacing the Keyboard Tools You need a small Phillips and a small flat-blade screwdriver to replace the keyboard. 7 Remove the three keyboard screws. Screw Preventing static electricity discharge The components inside your notebook are extremely sensitive to static electricity, also known as electrostatic discharge (ESD). ESD can permanently damage electrostatic discharge-sensitive components in your notebook. To avoid exposure to dangerous electrical voltages and moving parts, turn off your notebook and unplug the AC adapter, modem cable, and network cable before replacing a component. Screw Screw Warning Before working with notebook components, follow these guidelines: · · Avoid static-causing surfaces such as carpeted floors, plastic, and packing foam. Remove components from their antistatic bags only when you are ready to use them. Do not lay components on the outside of antistatic bags because only the inside of the bags provide electrostatic protection. The keyboard should easily fall into place. Press down on the cover in several places until it clicks in place. The cover is correctly mounted when you can run you finger along the cover and find no loose spots. The cover should be flat all the way across. Caution If the cover is not correctly replaced, your notebook could be damaged when you try to close the LCD panel. 14 Rotate the keyboard toward you so it lies keys-down on top of your notebook. 7 Close the LCD panel, then turn your notebook over so the bottom is facing up. 15 Lift the black connector clip, then remove the cable. Be careful not to touch or damage any other components. 9 Insert the battery(ies), then turn your notebook over. 10 Reconnect the optional port replicator. -ORConnect the power adapter, the modem cable, and the network cable. Connector 11 Reconnect all peripheral devices that were connected to the notebook and replace any PC Cards. 12 Turn on your notebook. 16 Lift the old keyboard away from the notebook. Technical Support See the label on the bottom of the notebook for Customer Care Information. [. . . ] 6 Turn your notebook over so the bottom is facing up, then remove the main battery and optional secondary battery. For more information, see "Changing Batteries" in your online hardware guide. 7 Loosen the wireless network bay cover screw (this screw cannot be removed), then remove wireless network bay cover. Tools Locating Components Wireless network bay Preventing static electricity discharge The components inside your notebook are extremely sensitive to static electricity, also known as electrostatic discharge (ESD). ESD can permanently damage electrostatic discharge-sensitive components in your notebook. To avoid exposure to dangerous electrical voltages and moving parts, turn off your notebook and unplug the AC adapter, modem cable, and network cable before replacing a component. Warning Screw Before working with notebook components, follow these guidelines: · · Avoid static-causing surfaces such as carpeted floors, plastic, and packing foam. [. . . ]