User manual TOSHIBA RAS-M07SKV-E SERVICE MANUAL

[. . . ] SVM-07034-2 SERVICE MANUAL SPLIT TYPE Indoor Unit <High Wall, Heat Pump Type> RAS-M07SKV-E RAS-M10SKV-E RAS-M13SKV-E RAS-M16SKV-E <High Wall, Cooling Type> RAS-M10SKCV-E RAS-M13SKCV-E RAS-M16SKCV-E R410A Revised May, 2009 CONTENTS 1. SAFETY PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . REFRIGERANT R410A . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] In that case, set the timer operation again. NOTE : The Everyday Timer is reset while a command signal can be received from the remote controller even if it stopped due to a power failure. ­ 41 ­ 9-4. Remote control and its functions 2 3 4 5 6 7 8 9 18 10 19 11 12 20 13 14 15 16 17 18 19 20 21 1 Infrared signal emitter Start/Stop button Mode select button (MODE) Temperature button (TEMP) Fan speed button (FAN Swing louver button (SWING) Set louver button (FIX) On timer button (ON) Off timer button (OFF) Sleep timer button (SLEEP) Setup button (SET) Clear button (CLR) Memory and Preset button (PRESET) One Touch button (ONE-TOUCH) High power button (Hi-POWER) Economy button (ECO) Quiet button (QUIET) Comfort sleep button (COMFORT SLEEP) Filter reset button (FILTER) Clock Reset button (CLOCK) Check button (CHK) 1 PRESET FAN TEMP 13 ONE-TOUCH 5 4 3 18 15 16 12 9 11 20 MODE 14 2 17 SWING FIX Hi-POWER ECO QUIET COMFORT SLEEP 6 7 8 10 21 19 TIMER ON SLEEP CLR OFF SET CHK FILTER CLOCK 9-4-2. ONE-TOUCH Press the "ONE-TOUCH" button for fully automated operation that is customised to the typical consumer preferences in your region of the world. The coutomised settings control temperature air flow strength, air flow direction and other settings to provide you alternate contact with "ONE-TOUCH" OF THE BUTTON. If you prefer other settings you can select from the many other operation functions of your Toshiba unit Press ONE-TOUCH : Start the operaton. 2. AUTOMATIC OPERATION To automatically select cooling, heating, or fan only operation. COOLING / HEATING / FAN ONLY OPERATION To automatically select cooling, heating, or fan only operation. Press HIGH MODE : Select Cool , Heat , or Fan only . 17°C, Heating : Max, 30°C, Fan Only: No temperature indication - 42 - 4. DRY OPERATION (COOLING ONLY) For dehumidification, a moderate cooling performance is controlled automatically. MODE : Set the desired temperature. 5. Hi-POWER OPERATION To automatically control room temperature and airflow for faster cooling or heating operation (except in DRY and FAN ONLY mode) Press HI-POWER : Start and stop the operation. 6. ECO OPERATION To automatically control room to save energy (except in DRY and FAN ONLY mode) Press ECO : Start and stop the operation. Note: Cooling operation; the set temperature will increase automatically 1 degree/ hour for 2 hours (maximum 2 degrees increase). For heating operation the set temperature will decrease. TEMPORARY OPERATION In case of the misplaced or discharged remote control · Pressing the RESET button, the unit can start or stop without using the remote control. · Operation mode is set on AUTOMATIC operation, preset temperature is 24°C and fan operation is automatic speed. TIMER OPERATION Setting the ON Timer Setting the OFF Timer Press Press Press OFF 1 2 3 Press Press Press ON : Set the desired ON timer. : Cancel the timer . : Set the desired OFF timer. : Set the timer. SET SET CLR CLR Everyday timer allows the user to set both the ON & OFF timers and will be activated on a daily basis. Setting Everyday Timer 1 Press ON : Set the ON timer. 3 Press SET . 2 Press OFF : Set the OFF timer. 4 Press button during the ( or ) mark flashing. SET · During the every day timer is activation, both arrows ( or ) are indicated. Note: · Keep the remote control in accessible transmission to the indoor unit; otherwise, the time lag of up to 15 minutes will occur. [. . . ] 2) Remove screw of earth lead attached to the end plate of the evaporator. 3) Remove the lead wire cover, and remove connector for the fan motor and connector for the louver motor from the electric parts box assembly. 4) Pull out TC sensor from sensor holder of the evaporator. 5) Pull out TCJ sensor from sensor holder of the evaporator. [. . . ]