User manual TOSHIBA RAV-SM800XT-E SERVICE MANUAL

[. . . ] 2003 (1) SERVICE MANUAL SPLIT TYPE RAV-SM560AT-E/RAV-SM800AT-E RAV-SM560UT-E/RAV-SM800UT-E RAV-SM560BT-E/RAV-SM800BT-E RAV-SM560KRT-E/RAV-SM800KRT-E RAV-SM560XT-E/RAV-SM800XT-E File No. A02-014 in the page of the following table has been changed, and the portion is expressed as mark. 2, 3, 5, 11, 20, 21, 29, 57, 59, 60, 63, 64, 168, 170 Cord Heater Installation Work Revised page R410A PRINTED IN JAPAN, Apr. , 2003 ToMo Revised. SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · Detection of error is performed as usual. However, do not use this function except case of Test Run because it applies load on the unit. Use either heating or cooling operation mode for [TEST]. NOTE : The outdoor unit does not operate after power has been turned on or for approx. After a Test Run has finished, push button again and check that [TEST] on LC display has gone off. (To prevent a continuous test run operation, 60-minutes timer release function is provided to this remote controller. ) <Wireless remote controller> (Option for 4-way air discharge cassette type) 1. Remove the adjuster attached with sensors from the ceiling panel. For removing, refer to the Installation manual attached to the ceiling panel. (Be careful to handle the adjuster because cables are connected to the sensor. ) Remove the sensor cover from the adjuster. Change ON of Bit [1: TEST] of the sensor P board switch [S003] to OFF. Mount the sensor cover and mount the adjuster with sensor to the ceiling panel. Push button on the wireless remote controller and select [COOL] or [HEAT] operation mode using button. (All the display lamps of sensors on the wireless remote controller flash during Test Run. ) · Do not perform Test Run operation in other modes than [HEAT] / [COOL] mode. · Detection of error is performed as usual. After Test Run operation, push button to stop the operation. Return Bit [1] of the sensor P board switch [S003] to the original position. Mount the adjuster with sensors to the ceiling panel. Bit 1 : OFF to ON S003 ON 4 3 2 1 Sensor cover Sensor P. C. board Adjust corner cap ­ 92 ­ 12-1-2. Setup to Select Function <Procedure> Use this function while the indoor unit stops. 1 2 3 4 5 Push SET , , and buttons concurrently for 4 seconds or more. displayed at the first time indicates the indoor unit address of the master unit in the group control. In this time, fan and flap of the selected indoor unit operate. Every pushing button, the indoor unit numbers in the group control are displayed successively. [. . . ] <Example for RAS-13JAVP-E> As shown in the left figure, remove the set of refrigeration cycle assembly from the outdoor unit base. * In this time, work attentively so that the cycle pipes are not damaged by dent or deformation. Apply protective measures to pipes if necessary. 2 Cord heater installation work Drill a hole on the outdoor unit base, and fix the cord heater to the outdoor unit base using P-shape clamp. Using a motor drill, etc. , drill Ø3. 2 holes to the existing emboss on the outdoor unit base. [. . . ]