User manual TOSHIBA RBC-EXW21E2 APPLICATION CONTROL MANUAL

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual TOSHIBA RBC-EXW21E2. We hope that this TOSHIBA RBC-EXW21E2 user guide will be useful to you.

Lastmanuals help download the user guide TOSHIBA RBC-EXW21E2.

Download

Manual abstract: user guide TOSHIBA RBC-EXW21E2APPLICATION CONTROL MANUAL

Detailed instructions for use are in the User's Guide.

 [. . . ] A04-007

APPLICATION CONTROL MANUAL
Super Modular Multi System
Heat Pump Type Cooling Only Type

R410A

Super Heat Recovery Multi System
Heat Recovery Type

CONTENTS
1 Outline of system and application control
1-1 1-2 1-3 1-4 Outline of application control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 List of application control models and setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Remote controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Application controls for remote controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  [. . . ] Check button CHECK button is used for check operation. During normal operation,  do not use this button. Temperature set button Adjusts required room temperature. Set required set temperature by pushing

6

Start/Stop button When the button is pushed,  operation starts,  and it stops by pushing the button again. When the operation stops,  the operation lamp and all displays disappear. Filter reset button Resets (Erases) "FILTER
" display. 

7

OPTION :

or

. 

Remote controller sensor Usually the TEMP. sensor of the indoor unit measured a temperature. A temperature around the remote controller can also be measured. For details,  contact the dealer from which you have purchased the air conditioner. 

84

Signal Receiving Part (TCB-AX21U(W)-E)
· The signal receiving part is mounted to the ceiling panel. 

Signal Receiving Part

10
2

8

9

4 3

1 4 5 2 3

N O

1

4

3 2 N O 1

N O

03 S0

7
03 S0 N O

1 2 3 4 5 6

Emergency operation button Signal receiving part The signal sent from the remote controller is received. Display lamp One of displays flashed while a trouble occurs. When the display lamp flashes,  refer to "Before asking of repair". lamp This lamp goes on during operation. lamp This lamp goes on while the timer is reserved. lamp · In heating operation this lamp in the following cases; The operation has started. · This lamp flashes while a trouble occurs. 

7 8

Trial ON switch (S003-1) This switch is not used in normal time,  but used in trial operation time. Master/Side remote controller switch (S003-3) [ ,  " ·e R Use this switch at the position of [S, R" ·e (PRIORITY)]. This switch can be used together with the wired remote controller. 

9 Fan speed change tap 1 (S003-2) 10 Fan speed change tap 2 (S003-4)
These switches are used to select DC motor speed of a 4-way cassette type indoor unit by the taps. When installing an indoor unit to a high ceiling surface or when changing the number of discharge ports,  perform setting referring to the next page. 

11

Address switch This switch distinguishes the signal,  send or receive. 

The following switches are provided to the rear side of the receiving part. For setup,  contact the shop which you purchased the unit. · If "pi,  pi" sound is heard,  the MODE lamp of the display lamp goes on,  and the alternately,  the operation is not performed with the desired mode. lamp and lamp flash

85

Signal Receiving Part (RBC-AX22CE)
· The signal receiving part is mounted to the ceiling panel. 

Signal Receiving Part

1 4 5
1 2 3
Temporary operation button Signal receiving part The signal sent from the remote controller is received. Display lamp One of displays flashed while a trouble occurs.  [. . . ] 1 minute) after turning off the power supplies of the air conditioner and the collective control remote controller. board may be damaged. 

In case of 4-way Air Discharge Cassette Type
No. 1 2 Procedure Using the spacer (A),  install the adapter P. C. board to the position of the electric parts box.  [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE TOSHIBA RBC-EXW21E2

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual TOSHIBA RBC-EXW21E2 will begin.