User manual TOSHIBA SATELLITE 2430-301

[. . . ] These copyrighted materials may be copied for private use at home only. If, beyond the limitation above, you copy (including to transform data formats) or modify these materials, transfer them or distribute them via the Internet without approval of copyright owners, you may be subject to claims for compensation for damage and/or criminal penalties due to infringements of copyrights or personal rights. Please remember to observe the copyright laws when you use this product to copy the copyrighted works or perform other actions. Please note that you may infringe the owner's rights protected by the copyright laws if you use the screen mode switching functions (e. g. [. . . ] Do not set the working drive to a slow device like a USB1. 1 hard disk drive or it will fail to write DVD. Do not perform any of the following actions: Operate the computer for any other function, including using a mouse to TouchPad or closing/Opening the LCD panel. Bump or cause vibration to the computer. Use the Mode control button and Audio/Video control button to reproduce music or voice. Install, remove or connect external devices, including the following: ExpressCard, SD card, USB devices, external display, i. LINK. Please verify your disc after recording important data. DVD-R/+R/+RW disc cannot be written in VR format. Not support to output VCD and SVCD format. About Straight to Disc Not support to record on DVD-R/+R disc Not support to record DVD+VR format by HDV HDV support to burn DVD-Video only DVD-VR format not support to add Menu 4. About recorded DVDs Some DVD-ROM drives for personal computers or other DVD players may not be able to read DVD-R/+R/-RW/-RAM discs. When playing your recorded disc on your computer, please use the DVD Video Player If you use an over-used rewritable disc, the full formatting might be locked. The Region Selection icon will appear in the Task Bar. Click the icon with the primary mouse button to display a list of regions that the modem supports. A sub menu for telephony location information will also be displayed. A check will appear next to the currently selected region and telephony location. Select a region from the region menu or a telephony location from the sub-menu. When you click a region it becomes the modem's region selection, and the New Location for telephony will be set automatically. When you select a telephony location, the corresponding region is automatically selected and it becomes the modem's current region setting. User's Manual 4-27 Operating Basics Properties menu Click the icon with the secondary mouse button to display properties menu on the screen. Settings You can enable or disable the following settings: AutoRun Mode The Region Select utility starts automatically when you start up the operating system. Open the Dialling Properties dialog box after selecting region The dialing properties dialog box will be displayed automatically after you select the region. Location list for region selection A submenu appears displaying location information for telephony. Open dialog box, if the modem and Telephony Current Location region code do not match A warning dialog box is displayed if current settings for region code and telephony location are incorrect. Modem Selection If the computer cannot recognize the internal modem, a dialog box is displayed. Select the COM port for your modem to use. Dialing Properties Select this item to display the dialing properties. If you are using the computer in Japan, the Telecommunications Business Law requires that you select Japan region mode. It is illegal to use the modem in Japan with any other selection. User's Manual 4-28 Operating Basics Connecting To connect the modem cable(optional), follow the steps below. The modular cable that comes with the computer must be used to connect a modem. [. . . ] For a printer, resolution is expressed in dots per inch (dpi). For a screen, it is expressed as the number of pixels available horizontally and vertically restart: Resetting a computer without turning it off (also called "warm boot", "soft reset" or "reboot"). A device that uses three input signals, each activating an electron gun for a primary additive color (red, green, and blue) or port for using such a device. RJ45: A modular LAN jack. S S/P DIF: A standard of digital interface for audio. [. . . ]