User manual TOSHIBA SATELLITE 4070

[. . . ] The warranty contained in the contract between the parties is the sole warranty of Toshiba International Corporation's UPS Division and any statements contained herein do not create new warranties or modify the existing warranty. Any electrical or mechanical modifications to this equipment, without prior written consent of Toshiba International Corporation will void all warranties and may void UL/CUL listing. Unauthorized modifications also can result in personal injury, death, or destruction of the equipment. UNINTERRUPTIBLE POWER SUPPLY If additional information or technical assistance is required beyond what is included in this manual contact Toshiba's marketing department by calling toll free (800) 231-1412, by e-mail at toshibaups@tic. toshiba. com, or write to: Toshiba International Corporation, 13131 W. [. . . ] A. 2 Once the option is set to the desired level, press and hold the Function Control button. This will save the new load shed level setting. The UPS will indicate that the value has been stored by blinking the LEDs. After blinking the LED for a short time the UPS will exit the programming mode and return to bypass operation. To return the system to normal operation switch the RUN/STOP switch back to the RUN position. Output Enable/Disable After Input Overvoltage Backup. The unit is now ready to change the output enable/disable after input overvoltage backup option. This is indicated by the 150% LED turning on. This setting determines whether the UPS will go to bypass in the case of an input overvoltage fault. To change this setting press and hold the function control button. B. 1 This setting is set to disable output at the factory. Unlock and remove the electronics module from the battery module. 2) Lock the two battery modules together. Plug the bottom battery module into the top battery module. 3) Lock the electronics module on to the top battery module. Plug the battery module into the electronics module. It is not necessary to stack the modules for the system to operate. Refer to the section entitled "UPS Connections: Standard Module Connections" on page 10 for an explanation of how to lock and unlock the modules. Figure 5 Expansion Battery Module Other Option Modules There are a number of other optional modules that can be ordered for the SATELLITE 4070 Series UPS system. Table 3 shows some of the available option modules. For information about options not listed here contact Toshiba's UPS Marketing Department at (800) 2311412 or by e-mail at toshibaups@tic. toshiba. com. Table 3 Option Modules Input Output Part No. [. . . ] (To start the UPS when the input power is outside of the allowable range see the section entitled "Starting on DC Power", page 13. ) When the UPS is started, if the RUN/STOP switch is in the STOP (bypass) position the unit will start in the on-line mode for 1 second before switching to bypass mode. If the input voltage is out of range the UPS will turn off the output after 1 second rather than switching to bypass. Appendix F: Unit Configuration Options The following chart shows the configuration options for each base model UPS. Model Number Description Available Option Modules Description UF1-BC-087 UF1-IO-015-6BG 48V battery module 208/240V input; 240V/120V output transformer module 120V input isolation transformer module 230V input; 230V output transformer module 230V input isolation, 230V output transformer module 48V battery module 208/240V input; 240V/120V output transformer module 230V input; 230V output transformer module 48V battery module 208/240V input; 240V/120V output transformer module 120V input isolation transformer module 230V input; 230V output transformer module 48V battery module 208/240V input; 240V/120V output transformer module 120V input isolation transformer module 230V input; 230V output transformer module UF1A1A015C6 1500VA Electronics Module UF1-IO-015-6AA UF1-IO-015-6EE UF1-IO-015-XEE UF1A1A015C6T UF1-BC-087 1500VA Electronics UF1-IO-015-6BG Module with internal isolation UF1-IO-015-6EE transformer UF1-BC-087 UF1A1A020C6 2000VA Electronics Module UF1-IO-020-6BG UF1-IO-020-6AA UF1-IO-020-6EE UF1-BC-087 UF1A1A024C6 2400VA Electronics Module UF1-IO-024-6BG UF1-IO-024-6AA UF1-IO-024-6EE \Appendix G: Weights and Dimensions Module Model No. UF1A1A015C6 UF1A1A015C6T UF1A1A020C6 UF1A1A024C6 UF1-BC-087 Module Weight Pounds Kilograms 26 46 30 30 51 12 21 14 14 23 Shipping Weight Pounds Kilograms 31 51 35 35 56 14 23 16 16 25 Electronics Module Dimensions are in inches [mm] Battery/Option Module Dimensions are in inches [mm] TOSHIBA INTERNATIONAL CORPORATION LIMITED WARRANTY POLICY (48 contiguous U. S. States, Canada, Mexico) (UNINTERRUPTIBLE POWER SUPPLIES-UPS) TOSHIBA INTERNATIONAL CORPORATION ("TIC") warrants that the SATELLITE 4070 Series Uninterruptible Power Supplies ("UPS") and Uninterruptible Power Supply Battery ("BATTERY") (external battery cabinet) sold by TIC to the end user ("User") shall be free of defects in material and workmanship. [. . . ]