User manual TOSHIBA SATELLITE C665

[. . . ] The information in this manual has been carefully checked and is believed to be accurate. These changes are incorporated in newer publication editions. Gateway 2000 may improve and/or change products described in this publication at any time. Due to continuing system improvements, Gateway 2000 is not responsible for inaccurate information which may appear in this manual. [. . . ] Double-click the System icon and select the Device Manager tab. Click the + next to PCMCIA socket to expand the list. Double-click PCIC or compatible PCMCIA controller. Selecting the PCIC or compatible PCMCIA controller properties 3. In the Controller Properties dialog box under Device usage click Disable in this hardware profile to clear the check box. Click OK. 38 Maintaining and Troubleshooting Your Solo Notebook Clearing the check box to enable the PCIC controller properties 4. When the PC Card (PCMCIA) Wizard appears, read the dialog box and click No, then click Next. Click No then click Next again in the following wizard dialog box. Follow the PC Card Wizard prompts, then click Finish. When asked to shutdown Windows, click Yes. Press the Power Button to restart the system. The figure below shows how your Texas Instruments PCI-1250 CardBus Controller appears in the Device Manager when properly installed Chapter 4: Installing Drivers and Related Software 39 Properly installed TI PCI-1250 CardBus Controller drivers in the Device Manager USB (Universal Serial Bus) USB is a new type of serial interface that serves as a single-port alternative to connecting devices that traditionally have required their own specific ports, such as printers, joystick/MIDI devices, external mouse, or keyboards. Click Start, Run, then type: a:\ usbupd1. exe click OK. The Updating Windows dialog box appears. Click Yes to continue. 42 Maintaining and Troubleshooting Your Solo Notebook 15. Click Start, Shutdown, Restart the computer?When completed, the correct USB driver appears in the Device Manager as shown below. Properly installed USB drivers shown in the Device Manager Installing software updates Install the following software updates to complete the system install. Installing the UHCD. SYS update 1. Place the uhcdupd. exe driver disk in drive A. Click Start, Run, then type: a:\ uhcdupd. exe then click OK. Click Yes to continue with the installation. Chapter 4: Installing Drivers and Related Software 43 4. When the UHCD drivers finish installing, remove the diskette. Click Start, Shut Down, Restart the computer?to initialize the update. Installing the VMMUSB supplement 1. [. . . ] for instructions on inserting memory modules. Eject the diskette from the floppy drive and press <Enter>. Close any programs you are not using. Data error Divide overflow error General failure reading drive C: Insufficient disk space Invalid password Keyboard stuck or key failure Memory size error Memory error Non-system disk or disk error Not enough memory Chapter 9: Troubleshooting Your Notebook 87 Print queue is full Wait until some files have been printed before sending additional files to the printer. Make sure the printer is not set to work "off-line. " If you print large or many files at one time to the printer you may want to add additional memory to the printer. [. . . ]