User manual TOSHIBA SATELLITE PRO 4280

[. . . ] This product incorporates copyright protection technology that is protected by method claims of certain U. S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited. [. . . ] · Advanced testing using individual hardware tests. The tests are designed to run after the system reboots. This ensures that the computer will be in a predictable state, so the diagnostic program can properly test the hardware components. The tests are non-destructive and are intended to preserve the state of the computer. The computer reboots when you exit the program so drivers can be loaded. To run the e-Diagtools diagnostic test 1. Click Start, Turn Off Computer, Restart. When the logo screen appears, press F10 to start the diagnostic test. The first time you run the program, you are prompted to select the language for the program. When the menu appears, press F2 to run e-Diagtools. When the Configuration Description appears, check the list of detected hardware. Press F2 to start the basic hardware test. · Press the UP and DOWN arrow keys to move among parameters in a menu. · Press + or ­ to move through values for the current parameter, or press ENTER to change a setting. After you select the options you want, press F10 or use the Exit menu to exit BIOS Setup. If the settings cause a conflict between devices during reboot, the system prompts you to run BIOS Setup, and marks the conflicting settings. For a complete list of BIOS Setup menus, settings, and options, see the Reference Guide on the Documentation Library CD included with your computer. 46 Startup Guide Troubleshooting and Maintenance Reinstalling and Updating Software Reinstalling and Updating Software You can use the QuickRestore System Recovery CD to recover the original software build for your computer. The QuickRestore System Recovery CD also provides Windows drivers specific to your computer to configure a custom system. You can find drivers in these locations: · On your computer's hard drive under C:\hp\Drivers. · On the QuickRestore System Recovery CD under \hp\Drivers. · On the Compaq Consumer Support Web site (www. compaq. com/consumersupport). This Web site contains the latest updates of software drivers for different operating systems. To recover the factory installation of your hard disk You can use the QuickRestore System Recovery CD to reinstall the original factory software on your computer's hard disk. You can also use the same process to create a Utility partition on a new hard disk. [. . . ] Performance limitations may occur when used in conjunction with some parts of the network. Telecom will accept no responsibility should difficulties arise in such circumstances. PTC200 5. 6. 1 (3) General Requirements (automatic dialing devices) This equipment shall not be set up to make automatic calls to Telecom's 111 Emergency Service. PTC200 7. 5. 2 (3) (4) Ringer Sensitivity This device may be subject to ringing or bell tinkle when certain other devices are connected to the same line. [. . . ]