User manual TOSHIBA SATELLITE 1640

[. . . ] Satellite 1620CDS/ 1640CDT User's Guide ® If you need assistance, please see Appendix E in this guide ii Models: Satellite 1620CDS/1640CDT Instructions for IC CS-03 certified equipment 1 NOTICE: The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, operational and safety requirements as prescribed in the appropriate Terminal Equipment Technical Requirements document(s). The Department does not guarantee the equipment will operate to the user's satisfaction. Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. [. . . ] Hold the CD by its edges, ensure it is dust-free, and place it carefully in the disc tray, with the label side up. Inserting a CD into the CD-ROM drive 4 Press down on the CD until the disc locks on the spindle. CAUTION: If the CD is not seated properly when you close the disc tray, the CD might be damaged and the tray may not open fully when you press the eject button. 5 Close the disc tray. Part I: Getting to Know Your Computer Learning the Basics Using compact discs 43 Removing a CD with the computer on 1 Press the eject button. CAUTION: Do not press the eject button while the computer is accessing the CD-ROM drive. If the CD is still spinning when you open the disc tray, wait for it to stop before you remove it. 2 3 Pull the disc tray until it is fully open, remove the CD, and place it in its protective cover. Close the disc tray. Removing a CD with the computer off 1 Insert a slender object, such as a straightened paper clip, into the manual eject hole. CAUTION: Never use a pencil to press the manual eject button. Pencil lead can break off inside the computer and damage it. 2 3 Pull the disc tray until it is fully open, remove the CD, and place it in its protective cover. Close the disc tray. Caring for compact discs Store your CDs in their original containers to protect them from scratches and keep them clean. Don't bend a CD or place heavy objects on top of it. Don't apply a label to, or otherwise mar, the surface of a CD. Part I: Getting to Know Your Computer 44 Learning the Basics Using PC Cards Hold a CD by its outside edge. Fingerprints on the surface of a CD can prevent the CD-ROM drive from reading the data properly. Don't expose CDs to direct sunlight or extreme heat or cold. To clean a CD, wipe it with a clean, dry cloth--starting from the center of the CD and wiping toward the outward edge. If necessary, moisten the cloth with water or a neutral cleaner (not benzine or rubbing alcohol). Let the CD dry completely before inserting it in the drive. Using PC Cards PC Cards expand your computer's capabilities and usefulness. You can purchase additional PC Cards from your dealer. Most PC Cards conform to the PCMCIA (Personal Computer Memory Card International Association) standard. Your Satellite computer comes with two stacked PC Card slots and supports three types of PC Cards: Type I cards and Type II cards are typically used for fax/ modems, memory storage, network cards, etc. You can install up to two of these cards, one in each slot. Type III cards are used for removable hard disks and other functions that require a larger card. You can install just one of these cards. Check the documentation that came with the PC Card to see if it conforms to the PCMCIA 2. 1 standard, or later. Other cards may work with your computer, but are likely to be much more difficult to set up and use. Part I: Getting to Know Your Computer Learning the Basics Using PC Cards 45 Inserting PC Cards PC Cards require Card and Socket Services software--a set of programs that acts as a translator between the PC Card and the computer, and that makes hot swapping (switching cards while the computer is on) possible. TECHNICAL NOTE: Windows 98 Second Edition provides the Card and Socket Services for your PC Card. Even if your PC Card comes with its own version of Card and Socket Services, you should use the files included in Windows 98 Second Edition. Some PC Cards do not support hot swapping. [. . . ] Rivium Boulevard 41 2909 LK Capelle a/d IJssel Scribona Norge A/S; Toshiba PC Service Stålfjæra 20, P. O. Box 51, Kalbakken 0901 OSLO Latvia Lithuania Tel: + 370 7 31 01 34 Fax: + 370 7 31 08 05 Luxemburg Morocco Tel: +212-2-30-65-35 Fax: +212-2-30-80-68 Tel: +356-49 36 04 Fax: +356-49 36 03 www. tabone. com. mt Tel: +31-10-2882-300 Fax: +31-10-2882-390 www. toshiba. nl Tel: +47-22-897-000 Fax: +47-22-897-389 www. toshiba. se Malta Netherlands Norway Part III: Appendixes International Warranty 129 Country Poland Address AC Serwis Sp. Partyzantów 71, 43-316 Bielsko-Biala Tel. , Fax, web Tel: +48 (0-33)8130-205 Fax: +48 (0-33)8130-209 www. techmex. com. pl Tel: +351-21-472-1730 Fax: +351-21-472-1739 Portugal Quinta Grande Assisténcia Técnica Informática Lda. Quinta Grande, 30 J; 2720-487 Alfragide Scop Computers SRL 162 Barbu Vacarescu St, Sector 2 71424 Bucharest HTC a. s. Dobrovicova 8; 81109 Bratislava Romania Tel: +40-1-231-4602 Fax: +40-1-231-4606 www. scop. ro Tel: +421-7-593345-50 Fax: +421-7-593345-55 www. htc. sk Tel: +386-61-718-000 Fax: +386-61-721672 www. inea. si Tel: +34-91-6606-700 Fax: +34-91-6606-760 www. toshiba. es Slovakia Slovenia Inea d. o. o. [. . . ]