User manual TOSHIBA SATELLITE L450D

[. . . ] First Cabin is a service mark of Fujitsu PC Corporation. The following are registered trademarks of IBM Corporation: IBM, IBM PC AT, IBM PS/2. The following are registered trademarks of Microsoft Corporation: MS, MS-DOS, Windows. PCMCIA is a trademark of the Personal Computer Memory Card International Association. [. . . ] Have an additional full-charged battery or your AC adapter ready for use. When the low battery warning occurs, immediately stop the movie and exit the DVD player. CAUTION If you do not stop the DVD player quickly and the LifeBook attempts to auto-suspend (critical battery low state) the LifeBook will shutdown improperly. If this occurs, you will need to perform a hard reset and follow the instruction, if any, presented to you before the system will reboot. 4. Manually place your LifeBook into suspend mode by depressing the Suspend button and replace the discharged battery with an additional full-charged 46 PC Cards PC Card Slot PC Card Eject Button Figure 4-6 Installing/Removing PC Cards PC Cards Your Fujitsu LifeBook supports Type I, Type II and Type III PC Cards, which can perform a variety of functions depending on which type of PC Card you install. You can install one or two PC Cards at a time, depending on its type. Type I and Type II PC Cards can be installed together, while Type III PC Cards must be installed alone. Some available PC Cards: s s s s s s s WARNING Do not insert a PC Card into a slot if there is water or any other substance on the card as you may permanently damage the card, your LifeBook, or both. Zoomed Video cards (Type II, Slot 1 only). Local area network (LAN) cards (Type II). Other PC Cards that conform to PCMCIA 2. 1 or CardBus standards. For further information, refer to the instructions supplied with your PC Card. 1. See your PC Card manual for specific instructions on the installation of your card. CAUTION The memory upgrade module can be severely damaged by electrostatic discharge (ESD). Be sure you are properly grounded when handling and installing the module. (c) Figure 4-7 Adding Memory to the LifeBook POINT The memory upgrade module is not something you routinely remove from your LifeBook. Once it is installed, you should leave it in place unless you want to increase system memory capacity. 4. Align the connector edge of the memory upgrade module, chip side up, with the connector slot in the compartment. Insert the memory upgrade module at a 45o angle and press it firmly onto the connector. Press the memory upgrade module down into the compartment until it locks underneath the retaining clip. You will hear a click when it is properly in place. Replace the cover over the memory tray and reinstall the three screws. 49 LifeBook C Series ­ Section Four REMOVING A MEMORY UPGRADE MODULE 1. Perform steps 1 through 3 of Installing a Memory Upgrade Module. Pull the clips sideways away from each side of the memory upgrade module at the same time. While holding the clips out, remove the module from the slot by lifting it up and pulling towards the back of your LifeBook. [. . . ] Naturally not all failures are predictable. SMART predictability is limited to those attributes which the drive can self-monitor. In those cases where SMART can give advance warning, a considerable amount of precious data can be saved. A specific technology of making RAM which does not require periodic data refreshing. [. . . ]