User manual TOSHIBA SD-V596SU

[. . . ] DVD VIDEO PLAYER & VIDEO CASSETTE RECORDER SD-V592SU SD-V596SU OWNER'S MANUAL Before connecting, operating or adjusting this product, please read this instruction booklet carefully and completely. ©2004 Toshiba Corporation This device does not tape-record copy protected DVD Video Discs. Safety Precautions CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. REGULATORY INFORMATION: FCC Part 15 This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] A tape is played back for the first time. Streaks or snow appear because of scratches on the tape. video picture one frame at a time while viewing a still picture. 3 To return to playback, press PLAY. Slow Motion 1 Press SLOW during playback or still mode. The tape will be played back at a speed 1/19 times slower than the normal speed. During slow playback, use CH/TRK (+/-) to minimize noise bands. If slow motion mode continues for more than 3 minutes, the DVD+VCR will automatically change to playback mode. Manual Tracking If noise appears on the screen during playback, press CH/TRK (+/-) until the noise on the screen is reduced. In case of vertical jitter, adjust these controls very carefully. Tracking is automatically reset to normal when the tape is ejected or the power cord is unplugged for more than 3 seconds. 2 To return to playback, press PLAY. Instant Skip This is useful for skipping commercials or short program segments. 1 Press INSTANT SKIP during the playback mode. The tape will fast forward picture search through 30 seconds of recording. The skipping time can be extended by pressing INSTANT SKIP. Subsequent presses result in advancing the fast forward picture search time by 30-second increments (maximum 3 minutes). Rewinding/Fast-forwarding Press REW (m) or FF (M) in the Stop mode. 2 When the search is completed, the DVD+VCR will go into playback mode automatically. 23 OPERATION Horizontal lines (noise bars) will appear on the TV screen. The audio is automatically muted during special effect modes, so there is no sound during search. During the high-speed picture search modes, a short period is needed to stabilize tape speed when re-entering the PLAY mode. Slight interference may be observed during this period. Operation with tape (Continued) VISS (VHS Index Search System) The VHS INDEX SEARCH SYSTEM enables you to locate the beginning of any recording made on this VCR. Whenever a recording begins, an invisible INDEX mark is recorded on the tape. Normal Recording Preparation: Turn on the power of both the DVD+VCR and TV. Tune the TV to the DVD+VCR output channel (CH 3 or 4) or set the TV's source selector to VIDEO. If a direct VIDEO/AUDIO connection is made between the DVD+VCR and the TV, set the TV's source selector to VIDEO. VISS Scan VISS SCAN lets you search out each VISS mark on the recorded tape and play 5 seconds before advancing to the next VISS mark. tape signals 1 Insert a cassettebuttonthat has VISSPLAYBACK marked. willonce during display winor STOP The VISS -- indicator appear in the 1 Insert a video cassette that the safety tab intact. 2 Select the desired channel by using CH/TRK (+/-). 3 Set the desired recording speed (SP or SLP) by pressing SP/SLP. This DVD+VCR is not designed to record in LP mode. If you are recording from another source via audio/video input jacks (at the Rear or Front panel), select the LINE1 or LINE2 by pressing INPUT SELECT. 3 dow. The indicator appears simultaneously during scanning. The tape will be rewound or rapidly advanced to the next signal marked. [. . . ] DURING THE PERIOD FROM 91 DAYS AND BEYOND, FROM THE PURCHASE DATE, TACP WILL EXCHANGE A DEFECTIVE DVD/VCR COMBINATION WITH A NEW OR REFURBISHED PLAYER FOR A NOMINAL FEE. YOU MUST CONTACT TOSHIBA'S CONSUMER SOLUTIONS CENTER FOR INSTRUCTIONS ON HOW TO PROCESS YOUR EXCHANGE REQUEST. THE CONSUMER IS RESPONSIBLE FOR ALL INBOUND TRANSPORTATION AND INSURANCE CHARGES FOR THE DVD/VCR COMBINATION TO THE EXCHANGE CENTER. *Rental Units The warranty for rental units begin with the first rental or thirty (30) days from the date of shipment to the rental firm, whichever comes first. [. . . ]