User manual TOSHIBA SG1700

[. . . ] IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. [. . . ] Clean the contacts occasionally with a dry cloth. 6 After the battery pack is fully charged; Operation While in use (Talk mode) While not in use (Standby mode) Approx. battery life up to 6 hours up to 7 days When TALK/BATT LOW LED blinks, all handset buttons are disabled and the battery needs to be charged. If you are during a call, you hear short beeps. Finish the call as soon as possible and place the handset on the base unit. Note If a call comes in when the battery is too low to operate properly, you will be unable to answer the call or the call will be disconnected. WALL MOUNTING MOUNTING ON A STANDARD WALL PLATE Insert the bracket's tab into the base's lower tab slots, then press down on the top of the bracket to snap it into the clip slots. Flip the switch hook tab over so the tab holds the handset. Raise the antenna. Telephone Line Cord Single-Line Telephone Jack (RJ11C) Power Outlet AC Adaptor (AC 120V, 60Hz) 7 · Route the cords through the guides. · Place the base unit on the posts of the wall plate and push down until it is firmly seated. · USE ONLY WITH Supplied AC ADAPTOR (TAC-1700; power source AC 120V, 60Hz/DC 9V). Notes · Do not use any outlet controlled by a wall switch. · If you don't have a standard wall plate, cut out the template below and use it to position two screws (minimum length of 1-3/8 inches) into the wall with the heads protruding about 3/16 inch. CUT CUT Wall mount template IMPORTANT: · Before mounting, select a wall area of sufficient strength. If mounting on wallboard or in an area of questionable strength, locate a stud for maximum support of your telephone. · Avoid electrical cables, pipes, or other items behind the mounting location that could cause a hazard. 8 LOCATIONS OF CONTROLS HANDSET CONTROLS Antenna Speed Dial Index Card (back) Write down numbers stored in memory. To take the original call back, press FLASH again. Note Pressing FLASH without receiving a Call Waiting signal may disconnect the current caller. 11 8. SENDING TONE SIGNAL (for Pulse service user) Even if you have Pulse service (the Tone-Pulse switch is set to Pulse). You can use this phone with banking and other phone services requiring touch tone signals. q Dial the service number and wait for the connection. w Press TONE then, enter the numbers required. You will hear the tones on the line. 9. MUTING Press MUTE to turn off the microphone during a conversation. The TALK/BATT LOW LED blinks. You may speak to someone in the room without the caller overhearing. To resume normal conversation, press MUTE or TALK . 10. PAGING To locate the handset (while it is off the base), press PAGE on the base unit. To stop paging, press PAGE or return the handset to the base unit. Notes · You cannot page the handset during a call. · Be careful not to close your ear to the ringer on the back side of the handset while paging, because it may be too loud. 11. OUT OF RANGE During a call, as you begin to move too far from the base, you first hear a clicking sound. [. . . ] · The battery was not fully charged at the initial charging. Charge the battery for 12 to 16 hours without any interruption. · The battery is several years old. · The battery is not installed correctly. [. . . ]