User manual TOSHIBA SG1801

[. . . ] Change the unit's display language as needed (page 13). (For Czech and Slovakia) This cordless telephone is possible to use according to General licence No. : VO-R/8/08. 2005-23 (for Czech), VPR-7/2001 (for Slovakia). Please read these operating instructions before using the unit and save them for future reference. TG8200_8220FX(e-e). book Page 2 Monday, August 6, 2007 5:25 PM Table of Contents Preparation Introduction . 10 Battery installation and replacement . [. . . ] i # i {ih} ("Off"): page 42 Change the unit's region setting ("Other"): page 26 Repeater Mode Country *1 KX-TG8220 *2 Change the recall time, if necessary, depending on the requirements of your service provider/telephone company or PBX. *3 When using the unit in Czech/Slovakia, select "100 msec. " as the recall time. If you change the unit's region setting/reset the base unit, the recall time will be reset to the default setting. In this case, select "100 msec. " again. *4 If you change the PIN, please make note of your new PIN. The unit will not reveal the PIN to you. *5 If you forget your PIN, consult your nearest Panasonic service centre. 25 TG8200_8220FX(e-e). book Page 26 Monday, August 6, 2007 5:25 PM | Base Unit Settings Special instructions for call options Setting call restriction You can restrict selected handsets from dialling certain numbers. You can assign up to 6 phone numbers to be restricted, and select which handsets will be restricted. Storing area codes here will prevent the restricted handsets from dialling any phone number in that area code. L To erase a restricted number, press {C/T}. Changing the unit's region setting/Resetting the base unit 1 " (centre of joystick) i | i # 2 3 4 {^}/{V}: "Other Options" i # {^}/{V}: "Country" i # {^}/{V}: Select the desired country. i# 1 2 3 4 " (centre of joystick) i | i # {^}/{V}: "Call Options" i # {^}/{V}: "Call Restrict" i # Enter the base unit PIN (default: "0000"). L If you forget your PIN, consult your nearest Panasonic service centre. Changing category ringtones If you select "Ext. Ringtone", the unit will use the external ringtone you set on page 21 when calls from this category are received. Ringtone". 1 2 3 4 5 n (left soft key) i " {^}/{V}: "Category" i # {^}/{V}: Select a category. i # {^}/{V}: Select the current setting of the category ringtone. i # {^}/{V}: Select the desired ringtone. i # i {ih} Changing category display colours If you select "Display Colour", the unit will use the display colour you set on page 21 when calls from this category are received. The default setting is "Display Colour". 1 2 3 4 n (left soft key) i " {^}/{V}: "Category" i # {^}/{V}: Select a category. i # {^}/{V}: Select the current setting of the category colour. i # 28 TG8200_8220FX(e-e). book Page 29 Monday, August 6, 2007 5:25 PM j Caller ID Service 5 {^}/{V}: Select the desired colour. i # i {ih} 3 4 {^}/{V}: "Erase" or "Erase All" i# {^}/{V}: "Yes" i # i {ih} Caller list Viewing the caller list and calling back 1 " (centre of joystick) i j i # Storing caller information into the handset phonebook 1 " (centre of joystick) i j i # 2 3 4 {^}/{V}: Select the desired entry. i" {^}/{V}: "Add Phonebook" i # Continue from step 3, "Adding entries", page 18. 2 Push the joystick down to search from the most recent call, or push the joystick up to search from the oldest call. [. . . ] Consult your service provider/telephone company. L When an error code ("FD", "FE", or "E0") is displayed, "Q" will not be displayed even if you have read the message. "FE" is displayed. "E0" is displayed. "Q" is not displayed after I read a message. Answering system (KX-TG8220) Problem The unit does not record new messages. Cause & solution L The answering system is turned off. [. . . ]