User manual TOSHIBA SL-9000-ESB

[. . . ] TEC Electronic Computing Scale SL-9000-ESB SERIES Owner's Manual Safety Summary Safety Summary Personal safety in handling or maintaining the equipment is extremely important. Warnings and Cautions necessary for safe handling are included in this manual. All warnings and cautions contained in this manual should be read and understood before handling or maintaining the equipment. Do not attempt to effect repairs or modifications to this equipment. [. . . ] 32 characters/line), and call one of them to print it on the label. <MENU> Group 1 8 Enter the grade line#. 32 chars. /line) (Refer to NOTE 2) ENTER PROG. <MENU> Group 1 Main <MENU> ESC. NOTES: 1. Print position of grade line can be changed by initial setting. Refer to page 11-4, for information regarding how to enter the Grade Line. 11-16 11. PROGRAMMING PROCEDURES 11. 9 SPEED KEY SETTING 11. 9 SPEED KEY SETTING Normal Mode Menu Group: 1 Item No. : 9 ESB Limited Spec. Mode Item No. : 8 The SL-9000 has a maximum of 70x2 speed keys which are very convenient to call PLUs quickly. (Refer to page 5-3 regarding the Key Layout. ) i <MENU> Group 1 9 Enter the Speed Key number (# 1~70 X 2) NEXT or PLU ENTER Select the 1st half or the 2nd half of the speed keys. i Enter the PLU#. 6 dig. ) ENTER PROG. <MENU> Group 1 Main <MENU> Enter the speed key number. ESC. Setting Department/Vendor Number <MENU> Group 1 9 AUTO CODE Enter a default department #. (1~99) ENTER ENTER Enter the department # or vendor #. (1 ~ 99) ENTER PROG. <MENU> Group 1 Main <MENU> Selecting items to be assigned to speed keys. (PLU #/VENDOR #/DEPT #) ESC. · Department Number When initial set #10-6 is set to "1", the six-digit PLU# is divided into two; the upper two digits are assigned to department #, and the lower four digits to PLU. The department # is automatically added in front of four-digit PLU# and treated as a six-digit PLU#. In case of "PROG. ", "Report", and "Reset" modes, PLU# is treated as a six-digit number. So the upper two digits are not treated as department #. Consequently the four-digit PLU# is available only in "REG. ", "M. DOWM", and "REWRAP" modes. NOTE: The default Dept. is two-digit serial number ranging from 0 to 99. No. · Vendor Number Vendor numbers can be set when the Initial Setting #11-1 is set to 1. Vendor numbers are assigned to the speed keys in two ways: 1 Individual vendor number: 00-39 Vendor# is assigned to the speed keys one by one. 2 Group vendor number: 0-, 1-, 2- and 3Maximum 10 vendor numbers can be assigned to one speed key, resulting in 4 speed keys in total. When assigning group vendor numbers to the speed keys, enter the first digit of the vendor key (0, 1, 2 or 3) plus a bar (-). Vendor numbers can be called whichever half of the speed keys are selected. PROGRAMMING PROCEDURES 11. 10 PRINT FORMAT 11. 10 PRINT FORMAT Normal Mode Menu Group: 2 Item No. : 0 ESB Limited Spec. [. . . ] NOTE: Be careful not to damage the print head when cleaning. If any label paste is found on the label on the cutter, wipe off paste with alcohol. After removing the label cutter, reattach it using the following procedure. 1. Install an unloaded label cassette on the scale. Install the label cutter, aligning the cutter notches with the screw holes. [. . . ]