User manual TOSHIBA STRATA CIX & CTX-DKT2204-CT

[. . . ] Digital Solutions Division Strata CIX and CTX DKT2204-CT/DKT2304-CT Cordless Digital Telephones User Guide July 2006 Publication Information Toshiba America Information Systems, Inc. , Telecommunication Systems Division, reserves the right, without prior notice, to revise this information publication for any reason, including, but not limited to, utilization of new advances in the state of technical arts or to simply change the design of this document. Further, Toshiba America Information Systems, Inc. , Telecommunication Systems Division, also reserves the right, without prior notice, to make such changes in equipment design or components as engineering or manufacturing methods may warrant. CIX-CTX-UG-CRDLS-VB Version B, July 2006 © Copyright 2006 Toshiba America Information Systems, Inc. Telecommunication Systems Division All rights reserved. [. . . ] Use #10 screws with anchoring devices suitable for the wall. · · To wall mount the base unit 1. Insert two mounting screws 3-15/16 inches apart. Allow about 3/16 of an inch between the wall and screw heads for mounting the telephone (shown right). Plug and secure the AC adapter cord by following Steps 2 and 3 of the "Standard Wall Plate Mounting" on page 19. Plug one end of the telephone line cord into the LINE jack on the base unit. Optionally, plug one end of a Strata DKT telephone into the PHONE jack. Then place the telephone cord(s) inside the molded channel(s) on the bottom of the wall mount stand. Place the base unit on the posts of the wall screws and push down until it's firmly seated. Plug the other end of the telephone cord into a telephone wall jack. Plug the AC adapter into a standard 120VAC wall outlet by following Step 7 of the Standard Wall Plate Mounting. 20 Strata CIX and CTX DKT2204-CT/DKT2304-CT Cordless Digital Telephones Installation Step 6: (Optional) Wall Installation Charging Unit Wall Mounting The charging unit is also designed to be wall mounted. Before mounting your charging unit, consider the following: · Select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall. Make sure the wall material is capable of supporting the weight of the charging unit. Use #10 screws with anchoring devices suitable for the wall material where the charging unit will be placed. · · DKT2204-CT 1. Insert two mounting screws 1-9/10 inches apart. Allow about 3/16 of an inch between the wall and screw heads for mounting the telephone. Plug the AC adapter into the charging unit as previously described. Wrap the AC adapter cord around the strain relief (shown right). 3. Place the charging unit on the posts of the wall screws and push down until it's firmly seated (shown right). Plug the AC adapter into a standard 120VAC wall outlet. Strata CIX and CTX DKT2204-CT/DKT2304-CT Cordless Digital Telephones 07/06 21 Installation Step 6: (Optional) Wall Installation DKT2304-CT 1. Insert two mounting screws 1-1/5 inches apart. Allow about 3/16 of an inch between the wall and screw heads for mounting the telephone (shown right). Pass the one end through the hole of the wall mount stand and plug it into the charging unit. [. . . ] For optimum range and performance from your handset, try the following: · Place the base units at least three to six feet away from the DKT; three feet from metal structures; and six feet from computers, fax machines or other electronic equipment. Use an AC outlet not associated with computer or electromagnetic equipment. Wherever possible, put the base unit in the middle of the coverage area. Mount the base unit high in the room for maximum range. [. . . ]