User manual TOSHIBA SX2001

[. . . ] SX-2001 IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. [. . . ] Finish the call as soon as possible and place the handset on the base unit. Note If a call comes in when the battery is too low to operate properly, you will be unable to answer the call or the call will be disconnected. WALL MOUNTING MOUNTING ON A STANDARD WALL PLATE Raise the antenna. Telephone Line Cord Single-Line Telephone Jack (RJ11C) AC Adaptor Power Outlet (AC 120V, 60Hz) 7 · Route the cords through the guides. · Place the base unit on the posts of the wall plate and push down until it is firmly seated. · USE ONLY WITH Supplied AC ADAPTOR (TAC-1700 power source AC 120V, 60Hz/DC 9V). Notes · Do not use any outlet controlled by a wall switch. · If you don't have a standard wall plate, cut out the template below and use it to position two screws (minimum length of 1-3/8 inches) into the wall with the heads protruding about 1/4 inch. CUT CUT Wall mount template IMPORTANT: · Before mounting, select a wall area of sufficient strength. If mounting on wallboard or in an area of questionable strength, locate a stud for maximum support of your telephone. The setting will remain in effect even after you hang up the current call. Note The maximum setting may be too loud because it is set for hearing aid compatibility. 6. REDIALING Press TALK and then press REDIAL/P (Redial/Pause). The last number called (up to 32 digits) will then be dialed again. 7. USING THE CALL WAITING SERVICE, ETC. To use this feature, you must subscribe to the Call Waiting service. When you hear a call-waiting tone while you are already talking on the phone, simply press FLASH . To take the original call back, press FLASH again. Note Pressing FLASH without receiving a Call Waiting signal may disconnect the current caller. 11 8. SENDING TONE SIGNAL (for Pulse service user) Even if you have Pulse service, you can use this phone with banking and other phone services requiring touch tone signals. q Dial the service number and wait for the connection. w Press TONE/ then, enter the numbers required. You will hear the tones on the line. 9. MUTING Press MUTE to turn off the microphone during a conversation. The TALK/BATT LOW LED blinks. You may speak to someone in the room without the caller overhearing. To resume normal conversation, press MUTE or TALK . 10. PAGING To locate the handset (while it is off the base), press PAGE on the base unit. To stop paging, press PAGE or return the handset to the base unit or press any key on the handset. Note You cannot page the handset during a call. 11. OUT OF RANGE During a call, as you begin to move too far from the base, you first hear a clicking sound. As you travel further, the noise increases. [. . . ] Place the handset on the base unit to recharge. · The base unit is located in a place with high interference. · Interference from TV, Microwave oven, Computer and electrical appliances . Press CHANNEL to select a clearer channel, or relocate the base unit. [. . . ]