User manual TOSHIBA SX2980

[. . . ] Using extra handsets, you can establish a 4-way conference call (2 H/S- Base Speaker Phone-an outside line, or 3 handsets- an outside line). Additionally, with 4-way conference using 2 handsets, another 2 handsets can establish an intercom call. You can now place a fully featured cordless handset anywhere in your home or office where AC power is available to connect the handset chargers. Note: Some illustrations in this manual may differ from the actual unit for explanation purposes. [. . . ] · If you make an outside call, or a call is received on the base during the operation, the operation is canceled. Pre-recorded message The following message is pre-recorded: "Hello, no one is available to take your call. Please leave a message after the tone. " Recording a personal outgoing message (Greeting) You can record a greeting up to 30 seconds long (must be more than 2 seconds long). 1) When the phone is in the standby mode, press and hold greeting. 2) Start your recording after the announcement "Record greeting". The message counter displays " ", then begins to count down. 3) When you have finished recording your greeting, press greeting, or set. You will hear a confirmation tone and your recorded greeting plays back for you. T H E I N T E G R AT E D A N S W E R I N G D E V I C E [ 51 ] Choosing between the two outgoing messages When the phone is in the standby mode, press greeting. Press greeting again when the outgoing message is played. Each time greeting is pressed, the outgoing message is switched between the pre-recorded and the personal outgoing message. Deleting an outgoing message To delete the personal outgoing message, press del while the message is playing. The system announces "Greeting has been deleted". Setting the base ringer volume · If an outside call is received during the operation, the operation is canceled. · If you press ringer/vol L in the maximum volume level (3) or ringer/vol M in the ringer off (0), you will hear a beep. You have four ringer volume options. The numbers " " through " " appear on the base as each hour is announced. 6) Press /SELECT or /SELECT until you hear the correct minute setting. The numbers " " through " " appears on the base as each minute is announced. 8) Press /SELECT or /SELECT until you hear the correct AM or PM setting. The message counter displays " " or " ". 9) Press SET to select the AM/PM setting. A confirmation tone sounds, the day and time you set are announced for your review. · Normally, if the system remains idle for 10 seconds after /SELECT or /SELECT is pressed, the system will return to standby. However, for setting the time, the idle time is extended to two minutes. · Press and hold /SELECT or /SELECT to quickly scroll through the numbers on the display. · Time stamp will not be heard until you have set the time. Setting a PIN code To play your messages from a remote location, you will need to enter a two-digit Personal Identification Number (PIN) code ( - ). To select a PIN code, perform the following steps: 1) Press CLOCK/MENU twice. [. . . ] To relieve strain on the DC plug when the phone is placed on a desk or table, wrap the power cord around the strain relief notch on the bottom of the base. NOTE: Place the power cord so that it does not create a trip hazard, or where it could become chafed and create a fire or other electrical hazards. Cordless Telephone Privacy Cordless telephones are radio devices. Communications between the handset and base of your cordless telephone are accomplished by means of radio waves which are broadcast over the open airways. Because of the inherent physical properties of radio waves, your communications can be received by radio receiving devices other than your own cordless telephone unit. [. . . ]