User manual TOSHIBA TCB-CA801BE INSTALLATION MANUAL

[. . . ] INSTALLATION MANUAL SUCTION CANVAS Model: TCB-CA281BE, CA501BE, CA801BE, CA1401BE PARTS LIST Parts name TCB-CA281BE Canvas fixing screw 4 (M4 x 30mm) Turnbuckle 4 Fixing screw (M4 x 10mm) 4 Suction canvas 1 TCB-CA501BE 4 4 4 1 TCB-CA801BE TCB-CA1401BE 10 4 4 1 10 4 4 1 Before installing the suction canvas, check the following : · Check that heat insulation treatment is provided for the connection piping of the air conditioner. [. . . ] (The screw-in margin should be about 10mm. ) (3)Move the suction canvas to the direction of the arrow on the left figure, and fix it by temporarily tightening 2 screws. (4)After fitting the remaining screws, tighten all the screws fully. Seal material Suction canvas Fixing screw Refer to step(2) Suction canvas Seal material (It continues to the back. ) Adjust the suction canvas Mount the ceiling panel. For details, refer to "Ceiling Panel Installation Manual". ·Adjustment height of the suction canvas is more than 100mm: Adjustment height for canvas duct Indoor unit more than 100mm Slit Ceiling panel Use the turnbuckle for adjustment. (1) Install the attached turnbuckle to the suction canvas, and hook the turnbuckle onto the chain so that there is no gap between the mounting ceiling surface and ceiling panel. (Before installing the turnbuckle, extend the screws so that the groove faces upward. ) (2) Turn the turnbuckle clockwise until there is no gap between the ceiling panel and ceiling surface. Turnbuckle ·Adjustment height of the suction canvas is between 40mm and 100mm: Hanging hole of the turnbuckle 40 100mm Use the chain for adjustment. Fix the chain with the chain fixing screws so that there is no gap between the ceiling panel and ceiling surface. [. . . ] CAUTION To prevent abnormal sounds, cut off the excessive portion of the chain. Cut off the chain. Chain fixing screw Adjustment height for canvas duct CH58263501 [. . . ]