User manual TOSHIBA TCB-PCIN2E INSTALLATION MANUAL

[. . . ] INSTALLATION MANUAL Error output control board l How to install (1) Be sure to turn off the power switch before installing. board by using the support on the upper side of the electric component box. [. . . ] Reassembling, repair, or modification of this accessory parts is strictry forbidden. l Failure to follow these directions can result in inflammation, earth leakage or abnormal operation causing electric shock or injury. Use the specified wires for wiring connect the terminals securely fix. To prevent external forces applied to the terminals from affecting the terminals. Do not install a location where flammable gasses may be present. l Fire may break out should flammable gas leak into the vicinity of the parts. Repair of the accessory parts must also carried out by personnel from dealer where it was purcased. l Fire may break out should flammable gas leak into the vicinity of the parts. CN511 GREEN Feature Operation and Error monitoring is possible by using Error output control board "TCB-PCIN2E" 79 69 4- 4 hole Dimension Size(mm):H22 x L73 x W79 Weight(g): 57 Wiring 73 63 Length Output wiring Size 0. 75mm2 Type Up to 200m 4-core, Terminal(Screw M3) Up to 400m 4-core, 1. 5mm2 * In conformity with design 60245 IEC 57 * * Shield wire Accesory parts No. 1 2 3 4 5 6 Parts name Connection cable Support to fix the board Earth screw Wire-clamp Screw for cable-clamp Banding band Q'ty 1 4 2 1 1 2 (1) Refer to the "Electric wiring diagram" when wiring. (2) Be sure to use the shield wire to prevent noise trouble, and perform the grounding at both sides of shield wires. (3) Fix the output wiring with the cable-clamp and banding band. Let the output wiring into the banding band and band it together with the other wiring. [. . . ] Display Relay capacity of "OPERATION" and "EMG" Below AC240V 0. 5A (COS =100%) When connecting load such as relay coil to "L1, L2" load, insert the noise surge absorber. Below DC24V 1A (Non-inductive load) When connecting load such as relay coil to "L1, L2" load, insert the the bypass circuit. [. . . ]