User manual TOSHIBA NB100

[. . . ] User's Manual NB 100 Series computers. toshiba-europe. com NB 100 Series Copyright © 2008 by TOSHIBA Corporation. Under the copyright laws, this manual cannot be reproduced in any form without the prior written permission of TOSHIBA. No patent liability is assumed, with respect to the use of the information contained herein. TOSHIBA NB 100 Series Portable Personal Computer User's Manual First edition August 2008 Copyright authority for music, movies, computer programs, data bases and other intellectual property covered by copyright laws belongs to the author or to the copyright owner. [. . . ] In hibernation mode, data will be lose if you remove the battery or disconnect the AC adaptor before the save is completed. Wait for the Disk indicator, optical disc drive indicator and external device indicator to go out. Remove all cables connected to the computer. Turn the computer upside down with the back of the computer facing you. Slide the battery pack locking latch toward the unlock position. Battery Pack Lock 1. 4. Slide the locking latch to the unlocked position User's Manual 6-9 NB 100 Series 6. Slide the battery release latch to free the battery pack for removal, then lift up the battery pack. Battery Release Latch Battery Pack Removing the battery pack 7. Pull the battery pack forward to remove it. For environmental reasons, do not throw away a spent battery pack. Please return spent battery pack to your TOSHIBA dealer. Installing the battery pack To install a battery pack, follow the steps below. The battery pack is a lithium ion battery, which can explode if not properly replaced, used, handled or disposed of. Dispose of the battery as required by local ordinances or regulations. Use only battery recommended by TOSHIBA as replacements. Be sure the computer's power is off and all cables are disconnected. Insert the battery pack. Battery pack Installing the battery pack 3. Push the battery pack until it is firmly seated. Slide the battery pack locking latch toward the lock position. 6-10 User's Manual Power and Power-up Modes Starting the computer by password If you have already registered a password, please enter the password manually to start the computer: To start up the computer with the user password, follow these steps: 1. Turn on the power as described in Chapter 3, Getting Started. The following message appears: Username At this point, the hot keys Fn + F1 to F9 do not work. They will function after you enter the password. Press Enter. Power-up modes The computer has the following power-up modes: Boot: Computer shuts down without saving data. Always save your work before you turn the computer off in boot mode. [. . . ] SCSI: Small Computer System Interface is an industry standard interface for connection of a variety of peripheral devices. SD Card: Secure Digital cards are flash memory widely used in a variety of digital devices such as digital cameras and Personal Digital Assistants. SECAM L: SECAM (Sequential Color Memory) is a broadcasting standard used in France. serial communications: A communications technique that uses as few as two interconnecting wires to send bits one after another. [. . . ]