User manual TOSHIBA USB PORT REPLICATOR II

[. . . ] 6 5 DRAIN PIPING WORK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 6 REFRIGERANT PIPING AND EVACUATING. . . . . . . . . . . . . . . . . . . . . . . . . 15 7 EVACUATING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 8 ELECTRICAL WORK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Do not insert your hands or others into the unit while the air conditioner is operating. CAUTION Do not install the air conditioner in a location subject to a risk of exposure to a combustible gas. If a combustible gas leaks and stays around the unit, a fire may occur. Upon approval of the customer, install the air conditioner in a place that satisfies the following conditions. Place where the unit can be installed horizontally. Place where a sufficient servicing space can be ensured for safety maintenance and check. Place where drained water will not cause any problem. Avoid installing in the following places. Place exposed to air with high salt content (seaside area), or place exposed to large quantities of sulfide gas (hot spring). (Should the unit be used in these places, special protective measures are needed. ) Place exposed to oil, vapor, oil smoke or corrosive gas. Place where organic solvent is used nearby. Place close to a machine generating high frequency. Failure to do so may result in unit damage and possible human injury. Any incomplete installation may also cause possible risk of human injury. Unpack the package, take out the product and then place it on the floor so that the same surface directs underneath as it is placed in the package. Never put the products in a pile or put weight on them, which are taken out from the packing box; otherwise there is a possibility to damage electric parts, fan parts, draining mechanism, and etc. OK NO GOOD If the both sides are turned over, a deformation of mounting metal of the ceiling panel which is sold separately, etc. Accordingly the product may be damaged and the installation becomes impossible in some cases. REQUIREMENT Strictly comply with the following rules to prevent damage of the indoor units and human injury. Do not place heavy objects on the indoor unit. (Even when units are still packaged) Always carry the unit as packaged from the factory wherever possible. If carrying in the indoor unit unpacked by necessity, be sure to use buffering cloth, etc. To move the indoor unit, hold the hanging brackets (4 positions) only. Do not apply force to other parts (refrigerant pipe, drain pan, foamed parts, or resin parts etc. ). [. . . ] Select ON of No. 4 of the selector switches (SW02). (OFF: A setting, ON: B setting) "B" setting "A" setting Check whether the changed remote controller can operate the indoor unit or not. Auto restart setting This product is designed so that, after a power failure, it can restart automatically in the same operating mode as before the power failure. INFORMATION How to set the Auto Restart Remove the cover of the electric parts box by taking off the mounting screws (3 positions) and pushing the hooking section. (The cover of the electric parts box remains hanged to the hinge. ) There are the selector switches (SW02) on the P. C. No. 3 of the selector switches (SW02) is provided for the selector switch. [. . . ]