User manual TOSHIBA VLC485

[. . . ] for TOSHIBA PRODUCT INSTRUCTIONS Specification Number Catalog Section 1. 1 GENERAL DESCRIPTION The VLC485 is a pan/tilt controller that ties together the major elements of an integrated system and provides a single human interface for the system. As such, the VLC485 can control pan/tilt units, interface to multiplexers, and communicate with a personal computer for computer-controlled operation. The LCD is used to display current status as well as to provide a menu system for setting operational parameters. The VLC485 is designed for desktop operation; all connectors are located in the rear of the unit so that all cables can be routed from the back of the unit. [. . . ] Press the STAR (*) key until the desired type is displayed. Press MENU to exit the menu mode. The VLC485 can connect to one main multiplexer and an additional expansion multiplexer if this feature is supported by the multiplexer. The main multiplexer is used to handle camera numbers 1 through 16 while the expansion multiplexer is used to handle camera numbers 17 through 32. 3. 3 PRESET LOCKOUT TO LOCKOUT THE ABILITY TO SET OR CLEAR PRESETS: Press the MENU button. Enter password if necessary. PRESET ENABLE YES PRESET ENABLE NO Use the POUND (#) key to scroll to Preset Enable. Press the STAR (*) key to change the setting. Press MENU to exit the menu mode. -4- 3. 4 AUTO TOUR DWELL Auto tour Dwell defines how long the pan/tilt will stay at each preset in the auto tour. This parameter is preset in the pan/tilt, but the VLC485 allows you to override that setting via the menu if this feature is supported by the pan/tilt. A range from 3 to 99 seconds can be set. Enter password if necessary. 3. 6. 2 TO ADD A CAMERA TO A SEQUENCE A sequence may contain up to 16 camera entries. If you have not filled a sequence and would like to add cameras to it, do the following. Use the POUND (#) key to scroll to Sequence. SET AUTOTOUR DWELL: Use the POUND (#) key to scroll to Set Auto tour Dwell mode. Use the keypad to enter the desired dwell time. Press MENU to exit the menu mode. SEQUENCE - ADD CAM: A blank space will appear after the last camera of the current sequence. To add a camera to the existing sequence enter the camera number on the key pad. Press the STAR (*) key, then press the SEQUENCE button. At that point another blank space will appear. You may add another camera to the sequence at this time (up to a total of 16), or press the SEQUENCE button again to review your entries. SET AUTOTOUR DWELL: 30 SEQUENCE - ADD CAM: 21 3. 5 BEEP ENABLE Also, if enabled, a brief beep will sound when each button is pressed. To prevent damage to the joy stick, a beep sound is activated whenever the joystick is at its maximum position. This function can be disabled in the Menu Mode. Enter password if necessary. 1, 2, 3. . . 3. 6. 3 TO CHANGE A CAMERA IN A SEQUENCE You may change any entry in a sequence at any time. Remember that these changes overwrite your existing sequence. [. . . ] Cable Runs - All cable runs must be within permissible distance. Mounting - This unit must be properly and securely mounted to a supporting structure capable of sustaining the weight of the unit. The installation should be made by a qualified installer. The installation should be in compliance with local codes. [. . . ]